User manual INDESIT KD3G11SG

[. . . ] Before doing any cleaning, disconnect the appliance from the electricity (by pulling out the plug orturning off the general switch in your home); it is not sufficient to place the temperature regulation knob on to cut off the power. Before disposing of your old appliance, remember to break or remove the lock as a safety measure to protect children who might lock themselves inside the appliance when playing. If your appliance is not operating properly, before calling your after-sales service read the chapter on "Trouble Shooting" which might help you resolve the problem. Do not attempt to repair the fault by intervening on the internal components. [. . . ] Do not use electric appliances inside the compartment for food storage, if these are not those recommended by the manufacturer. At the end of the functional life of your appliance ­ containing cyclopentane gas in the insulation foam and perhaps gas R600a (isobutane) in the refrigeration circuit ­ the latter should made safe before being sent to the dump. For this operation, please contact your dealer or the Local Organisation in charge of waste disposal. Installation To ensure that the appliance operates properly and to reduce energy consumption, it is important that the appliance is installed correctly. with a standard earthing wire in accordance with safety standards for 46/90 systems. If the socket is not fitted with an earthing wire, the manufacturer will not be held liability for any damages and or injuries arising out of the use of the appliance. Do not use multiple sockets or adapters. Position the appliance in such a way that you can access the socket where it is plugged in. Ventilation The compressor and condenser generate heat and, therefore, need to be ventilated properly. Rooms with less than perfect ventilation are not very suited for installation of the appliance. Therefore, it should be installed in a room with an opening (window or French window) that provide the appropriate amount of air re-circulation. It is also important that the room not be too humid. During installation, make sure not to cover or obstruct the grates that allow for proper ventilation of the appliance. Insufficient power? The electrical socket must be able to handle the maximum power load of the appliance, which is indicated on the rating plate located at the bottom left next to the vegetable crisper. Away from Heat Avoid positioning the appliance in a place where it is directly exposed to sunlight or near an oven, cook top or the like. Before making the electrical connection . . . After the appliance has been delivered, place it in the vertical upright position and wait at least 3 hours before inserting the plug into the socket in order to ensure that it functions properly. Electrical Connection and Earthing Before proceeding with the electrical connection, make sure that the voltage indicated on the rating plate, located at the bottom left near the vegetable crisper, corresponds to the mains voltage in your home and that the socket is fitted 1 GB Electrical connection Your appliance is now supplied with a 13 amp fused plug that can be plugged into a 13 amp socket for immediate use. - Remember to follow our instructions on the storage life of foods: If not stored correctly, even the freshest food will deteriorate quite quickly. - Contrary to popular belief, cooked foods do not keep longer than fresh food. - Do not store liquids in unsealed containers since this will increase the humidity and lead to the formation of frost in the refrigerator. 5 GB Energy Saving Tips - Install the Appliance Correctly This means that the appliance should be installed away from heat sources or direct sunlight in a well ventilated room. - Keep the Door Closed Open the refrigerator only when necessary; remember that every time you open the door most of the cold air will be lost. To bring the temperature back to the proper level, the motor must run for a considerable amount of time, consuming a substantial amount of energy. - Correct Temperature Settings Set the refrigerator temperature knob to one of the middle settings. Very cold temperature settings will not only consume a great deal of energy but will neither improve nor lengthen the storage life of the food. Excessively cold temperatures may ruin vegetables, cold cuts and cheese. - Check the Seal on the Door Keep the seal clean and soft so that it fits tightly against the door to ensure that no cold air is lost. - Do Not Overfill Your Appliance Remember that proper storage of food requires good air circulation. Overfilling your appliance will hamper proper air circulation and overwork the compressor. - Never Put Food in the Refrigeror while Still Hot A container of hot food in the refrigerator will increase the temperature significantly; allow food to cool to room temperature before storing. Caring for Your Appliance Before doing any cleaning, disconnect the appliance from the electricity (by pulling out the plug or turning off the general switch in your home). Defrosting WARNING: do not damage the refrigeration circuit. Do not use mechanical devices or other tools to speed up the defrosting process, unless they have been recommended by the manufacturer. Models without an Ice Unit The evaporator defrosts automatically during operation; the defrost water drips into the drain, is collected in a special tray and then evaporates. Clean the defrost water drain hole periodically (see fig. 1) to prevent water from collecting on the bottom of the refrigerator instead of flowing out. Fig. [. . . ] 2 Cleaning and Maintenance - Your appliance is manufactured with hygienic, odourless materials. To preserve these characteristics, always use sealed containers to store foods in order to prevent spills, stains and the formation of difficult to remove odours. - Only use a water and bicarbonate solution to clean the applianc. Clean the internal and exterior of your appliance with a sponge soaked in a warm water and sodium bicarbonate solution, which is also a good disinfectant. [. . . ]