User manual INDESIT KN1G11S(W)/I

[. . . ] Using the hob Using the oven Oven cooking advice table precautions and tips , 22 General safety Disposal Respecting and conserving the environment care and maintenance , 23 Switching the appliance off Cleaning the appliance Replacing the oven light bulb Gas tap maintenance Assistance Before operating your new appliance please read this instruction booklet carefully. The disposal of combustion fumes should be Guaranteed using a hood connected to a safe and Please keep these operating instructions for future Make sure that the instructions are kept Fan that begins to operate automatically every time With the appliance if it is sold, given away or moved. The appliance must be installed by a qualified Professional according to the instructions provided. Any necessary adjustment or maintenance must be We recommend cleaning the oven before using it For the first time, following the instructions provided The appliance may only be installed in permanentlyventilated rooms, according to current national legislation. [. . . ] For each BURNER knob there is a complete ring showing the strength of the flame for the relevant burner. To light one of the burners on the hob: 1. Bring a flame or gas lighter close to the burner. Press the BURNER knob and turn it in an anticlockwise direction so that it is pointing to the maximum flame setting E. Adjust the intensity of the flame to the desired level by turning the BURNER knob in an anticlockwise direction. This may be the minimum setting C, the maximum setting E or any position in between the two. To obtain these settings, turn the knob counterclockwise with respect to the off position. To turn off the burner, turn the knob clockwise until it stops (corresponding again with the · These models can be The device itself (see detail C Important: Since the hob burners are equipped with a Safety device, you must hold the control knob in for about 6 seconds after the burner has been lighted to allow the gas to pass until the safety thermocouple has heated. Notice: The first time you use your appliance, we recommend that you set the thermostat to the highest setting and leave the oven on for about half an hour with nothing in it, with the oven door shut. Then, open the oven door and let the room air. The odour that is often detected during this initial use is due to the evaporation of substances used to protect the oven during storage and until it is installed. Attention: Only use the bottom shelf of the oven when using the grill to cook. For all other types of Cooking, never use the bottom shelf and never place anything on the bottom of the oven when it is in Operation because this could damage the enamel. Always place your cookware (dishes, aluminium foil, ) on the grate provided with the appliance Inserted especially along the oven guides. With these two controls you can select the different functions of the oven and choose the cooking temperature suitable for the food you are preparing. The different cooking functions are set up by operating the two knobs: The selection knob the thermostat knob in the oven panel. For any selection-knob setting different from idle, identified by the "0", the oven light turns on; the Knob setting marked 8 permits turning on the oven Light without any heating element being switched on. When the oven light is on, it means that the oven is in use, and it will remain on for the entire time the oven is being used. Practical advice on using the burners For the burners to work in the most efficient way possible and to save on the amount of gas consumed, it is recommended that only pans that have a lid and a flat base are used. They should also be suited to the size of the burner. To identify the type of burner, please refer to the diagrams contained in the "Burner and nozzle specifications". Practical advice for burner use In order to get the maximum yield it is important to remember the following: ? [. . . ] Never use steam cleaners or pressure cleaners on the appliance. The stainless steel or enamel-coated external parts and the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and neutral soap. Use specialised products for the removal of stubborn stains. After cleaning, rinse well and dry thoroughly. [. . . ]