User manual INDESIT KN6C61AWF

[. . . ] € pour effectuer les raccordements électriques illustrés figure, utilisez les deux pontets placés dans le boîtier (voir figure - référence “P”) P 4 2 2 P N L1 !*N’existe que sur certains modèles 11 Operating Instructions COOKER AND OVEN GB FR Français, 1 GB English, 12 Contents Installation, 13-14 Positioning and levelling Electrical connection Table of characteristics Description of the appliance, 15 Overall view Control panel Display Start-up and use, 16-19 Setting the clock Setting the timer Using the oven Cooking modes Programming cooking Practical cooking advice Oven cooking advice table KN6C61A/FR KN6C66A/FR Using the glass ceramic hob, 20 Switching the cooking zones on and off Cooking zones Precautions and tips, 21 General safety Disposal Respecting and conserving the environment Care and maintenance, 22-23 Switching the appliance off Cleaning the appliance Replacing the oven light bulb Cleaning the glass ceramic hob Assistance Installation !Please keep this instruction booklet in a safe place for future reference. Make sure the booklet remains with the appliance if it is sold, given away or moved. [. . . ] Generally speaking, cooking on the rack in position 4 takes longer: we recommend that the pizza cooked on the lowest rack position is removed first, followed by the pizza cooked in position 4 a few minutes later. € Place the dripping pan on the bottom and the rack on top. timer* To activate the Timer proceed as follows: 1. Turn the TIMER knob in a clockwise direction 4 for almost one complete revolution to set the buzzer. Turn the TIMER knob in an anticlockwise direction 5 to set the desired length of time. 17 GB Planning cooking with the electronic programmer* Setting the clock After the appliance has been connected to the power supply, or after a blackout, the display will automatically reset to 0:00 and begin to blink. Press the COOKING TIME button and the COOKING END TIME simultaneously. Within 4 seconds of having pressed these buttons, set the exact time by pressing the + and buttons. The + button advances the hours and the button decreases the hours. Once the time has been set, the programmer automatically switches to manual mode. Setting the timer The timer enables a countdown to be set, when the time has elapsed a buzzer sounds. The display shows: Next the desired cooking end time must be set: 4. Within 4 seconds of having pressed this button, set the desired amount of time by pressing the + and - buttons. If, for example, you wish to set a cooking time of 30 minutes, the display will show: N 3. 4 seconds after the buttons are released, the current time (for example 10. 00) reappears on the display with the symbol m and the letter A (AUTO). 18 Correcting or cancelling previously set data The data entered can be changed at any time by pressing the corresponding button (TIMER, COOKING TIME or COOKING END TIME) and the + or - button. When the cooking time data is cancelled, the cooking end time data is also cancelled automatically, and vice versa. If the oven has already been programmed, it will not accept cooking end times which are before the start of the programmed cooking process. The glue applied on the gaskets leaves traces of grease on the glass. Before using the appliance, we recommend you remove these with a special nonabrasive cleaning product. During the first few hours of use there may be a smell of rubber which will disappear very quickly. [. . . ] € Clean the glass part of the oven door using a sponge and a non-abrasive cleaning product, then dry thoroughly with a soft cloth. Do not use rough abrasive material or sharp metal scrapers as these could scratch the surface and cause the glass to crack. € The accessories can be washed like everyday crockery, and are even dishwasher safe. € Dirt and grease should be removed from the control panel using a non-abrasive sponge or a soft cloth. [. . . ]