User manual INDESIT KP59MS

[. . . ] Please read these instructions carefully before using this product, and save this manual for future use. 16 Tips for Taking Pictures in the Water . Book 3 ページ ２０１３年１月１６日　水曜日　午前１１時３５分 ENGLISH Before Use • This Marine Case is designed for a Panasonic Digital Camera. € In the case of water leakage due to insufficient care, Panasonic is in no way liable for damage to any products (digital camera, batteries, card etc. [. . . ] There are no scratches or squashed parts on the O-ring. Thoroughly wipe any grease off your hands with a dry cloth. Afterwards wash thoroughly with fresh water. π  • Check that no foreign materials are sticking to the outer surface of the Oring or the buckle on the front case and then close the Case. Notes • To keep the Case completely airtight, do not scratch the surface of the O-ring that • Never use an O-ring that has been scratched or damaged by dirt etc. This will • Each time you use the Case, remove the O-ring and check that there is no dirt, sand, hair or other foreign materials in the O-ring groove and then apply a thin coat of grease (supplied). If you apply too much grease, dirt and the dust may stick to the O-ring causing water leakage. € Be sure to bring a spare O-ring in case the O-ring that you are using becomes damaged or scratched. Comes into contact with the sides of the Case. (ENG) VQT4V83 11 DMW-MCFT5_PP&E-VQT4V83. Book 12 ページ ２０１３年１月１６日　水曜日　午前１１時３５分 Checking the Case is Waterproof After setting the O-ring, check that no water leaks into the Case by submerging it in a water tank, bath tub etc. To prevent the Case from becoming fogged up, insert the silica gel about 1 to 2 hours before using the Case. € Silica gel Digital Camera • When inserting the silica gel, bend it as shown in the illustration below and then insert it as far as possible. If you close the Case with the silica gel not fully inserted, the silica gel will get caught in the Oring causing water leakage. Book 15 ページ ２０１３年１月１６日　水曜日　午前１１時３５分 • Check that the buckle is closed firmly. 5 After you have attached the digital camera, check one more time that no water leaks into the Case. (P12) Notes • Be careful not to get the shading hood dirty with fingerprints etc. € Check one more time that the O-ring is fitted evenly into the O-ring groove. Be sure to wipe the front glass before taking pictures. 16 VQT4V83 (ENG) DMW-MCFT5_PP&E-VQT4V83. Book 17 ページ ２０１３年１月１６日　水曜日　午前１１時３５分 Tips for Taking Pictures in the Water It is recommended to use the Recording Mode (Advanced Underwater) appropriate for underwater when recording underwater. It may not be possible to record images with intended brightness or color depending on the recording conditions (depth/weather/subject), so try using following functions together. [. . . ] € Never use an O-ring that has been scratched or damaged by dirt etc. € After replacing the O-ring, when not in use for a long period of time, after attaching the digital camera or when replacing the battery, if the marine case is opened please thoroughly check the O-ring for damage or any cracks. After checking, shut the marine case, immerse in water (a water tank or a bath tub) for approximately 3 minutes or more, then check that there are no water leaks. (P12) • O-rings are consumable products. [. . . ]