User manual INDESIT P 640 A

[. . . ] Choose the most appropriate one for the diameter of the cookware being used. The burner can be regulated with the corresonding control knob by using one of the following settings: Off High Low The symbols near the knobs also show the position of Lighting the burners Automatic ignition "D": · turn the relative knob counter-clockwise until the pointer is on the high-flame symbol; · press the automatic gas ignition by pushing the button marked with the symbol ; · Checking that the flame is stable. For minimum power, turn the knob towards the low flame symbol. Intermediate positions are possible by putting the knob anywhere between the high and the low flame symbol. the relative burner on the hob. 1 To turn off the burner, turn the knob clockwise to the off position " " . [. . . ] The burner does not light or the flame is not uniform around the burner. Check to make sure that: · The gas holes on the burner are not clogged; · All of the movable parts that make up the burner are mounted correctly; · There are no draughts around the cooking surface. The burner does not remain on when set to "Low". Check to make sure that: · The gas holes are not clogged. · There are no draughts near the cooking surface. · The minimum has been adjusted correctly (see the section entitled, "Minimum Regulation"). Check to make sure that: · The bottom of the cookware is perfectly flat. · The cookware is centered correctly on the burner or electric hot plate. · The support grids have not been inverted. If, despite all of these checks, the cooktop does not function properly and problem persists, call the nearest Merloni Elettrodomestici Customer Service Centre, informing them of: - The type of problem. - The abbreviation used to identify the model (Mod. Air from the adjoining room to the one to be ventilated may be made to freely pass through permanent apertures with a cross section at least equal to that indicated above. These apertures may also be obtained by increasing the gap between the door and the floor (fig. 3B). If an electric fan is used for extracting the combustion products, the ventilation aperture must be increased in relation to its maximum performance. The electric fan should have a sufficient capacity to guarantee an hourly exchange of air equal to 35 times the volume of the kitchen. Prolonged, intensive use of the appliance may require extra ventilation, e. g. an open window or a more efficient ventilation system by increasing the extraction power of the electric fan if installed. Liquid petroleum gas descends towards the floor as it is heavier than air. Apertures in the outside walls in rooms containing LPG cylinders should therefore be at floor level, in order to allow any gas from leaks to be expelled. Do not store LPG cylinders (even when empty) in basements/rooms below ground level; it is advisable to keep only the cylinder in use in the room at any one time and connected far from heat sources which could raise its temperature to above 50 °C. Fitting into modular kitchen units For correct operation of the hob built into a kitchen unit or other compartment, the latter must be suitable. The installation diagram plus dimensions of the housing hole is given in fig. [. . . ] Connect the Brown wire to the terminal marked "L" or coloured Red. Connect the Blue wire to the terminal marked "N" or coloured Black. FAILURE TO OBSERVE THE ACCIDENT-PREVENTION REGULATIONS RELIEVES THE MANUFACTURER OF ALL LIABILITY. Connecting the supply cable to the mains electricity supply For models supplied without a plug, fit a standard plug, suitable for the load indicated on the rating plate, onto the cable and connect to a suitable socket. To connect directly to the mains supply, a double-pole switch with a contact separation of at least 3 mm suitable for the load and complying with current standards and regulations, must be fitted between the appliance and the mains supply outlet. [. . . ]