User manual INDESIT PI640

[. . . ] Pass them on to possible new owners of the appliance. Adjacent Room Room to be Vented Enlarging the ventilation slot between window and floor. The system can also provide the air needed for combustion indirectly, i. From adjacent rooms fitted with air circulation tubes as described above. [. . . ] The cable must be checked regularly and replaced by authorised technicians only (see Assistance). The manufacturer declines any liability should these safety measures not be observed. There is an adjustable L-shaped pipe fitting on the appliance supply ramp and this is fitted with a seal in order to prevent leaks. The seal must always be replaced after rotating the pipe fitting (seal provided with appliance). These pipes must be installed so that they are never longer than 2000 mm when fully extended. Once connection has been carried out, make sure that the flexible metal pipe does not touch any moving parts and is not compressed. Only use pipes and seals that comply with current national regulations. Checking the tightness of the connection !When the installation process is complete, check the pipe fittings for leaks using a soapy solution. Adapting to different types of gas To adapt the hob to a different type of gas other than default type (indicated on the rating plate at the base of the hob or on the packaging), the burner nozzles should be replaced as follows: 1. Remove the hob grids and slide the burners off their seats. Should the gas pressure used be different (or vary slightly) from the recommended pressure, a suitable pressure regulator must be fitted to the inlet pipe (in order to comply with current national regulations). DATA PLATE Electrical connections voltage of 220-230V ~ 50/60Hz or 220-240V ~ 50/60Hz (see data plate ) maximum power absorbed 1500W This appliance conforms to the following European Economic Community directives: -73/23/EEC dated 19/02/73 (Low Voltage) and subsequent amendments - 89/336/EEC dated 03/05/89 (Electromagnetic Compatibility) and subsequent amendments - 93/68/EEC dated 22/07/93 and subsequent amendments. 78 MJ/m3 (1) Only for appliances with the security device. s R S A S R A S TC S A PI 640 PI 640 A PI 640 IB PI 640 AS PI 640 A R PI 631 PI 631 IB PI 640 AST !The PI 640 AST hob can only be installed above built-in ovens with a cooling ventilation system. 17 Description of the appliance GB Overall view GAS BURNERS ELECTRIC HOTPLATE* Support Grid for COOKWARE ELECTRIC HOTPLATE indicator light* Control Knobs for GAS BURNERS and ELECTRIC HOTPLATES* GAS BURNERS button* SAFETY DEVICES* Ignition for GAS BURNERS* • ELECTRIC HOTPLATES may have different diameters and operate at different power levels. These power levels may be “normal” or “rapid” (the latter may be distinguished from the others by a red spot in the middle of the hotplate). • The ELECTRIC HOTPLATE INDICATOR LIGHT switches on whenever the selector knob is moved from the ‘off’ position. Use the diameter of the cookware to choose the most appropriate burner to cook with. • Control Knobs for GAS BURNERS and ELECTRIC PLATES* adjust the power or the size of the flame. GAS BURNER ignition* enables a specific burner to be lit automatically. [. . . ] • It is usually enough to wash the hob with a damp sponge and dry it with absorbent kitchen roll. • The removable parts of the burners should be washed frequently with warm water and soap and any burnt-on substances removed. • For hobs which ligth automatically, the terminal part of the electronic instant lighting devices should be cleaned frequently and the gas outlet holes should be checked for blockages. • The electric hotplates should be cleaned with a damp cloth and lubricated with a little oil while still warm. [. . . ]