User manual INDESIT RA 28 I

[. . . ] Before inserting the plug into the electrical socket ensure the following: The appliance is earthed and the plug is compliant with the law. The socket can withstand the maximum power of the appliance, which is indicated on the data plate located on the bottom left side of the fridge (e. The voltage must be in the range between the values indicated on the data plate located on the bottom left side (e. If the socket is incompatible with the plug, ask an authorised technician to replace it (see Assistance). [. . . ] The appliance must be switched off and the plug must be pulled out before cleaning the appliance. If the frost layer is greater than 5 mm, it is necessary to defrost manually: 1. Wrap frozen foods in newspaper and place them in another freezer or in a cool place. Leave the door open until the frost has melted completely. This can be made easier by placing containers with lukewarm water in the freezer compartment. Clean and dry the freezer compartment carefully before switching the appliance on again. Until the ideal storage conditions have been restored, before placing food in the freezer compartment. Replacing the light bulb To replace the light bulb in the refrigerator compartment, pull out the plug from the electrical socket. The appliance is manufactured with hygienic materials which are odour free. In order to maintain an odour free refrigerator and to prevent the formation of stains, food must always be covered or sealed properly. If you want to switch the appliance off for an extended period of time, clean the inside and leave the doors open. Do not use objects with sharp or pointed edges to defrost the appliance as these may damage the refrigeration circuit beyond repair. Access the light bulb by removing the cover as indicated in the diagram. Replace it with a similar light bulb within the power range indicated on the cover (15W or 25W). The appliance was designed and manufactured in compliance with international safety standards. The following warnings are provided for safety reasons and must be read carefully. This appliance complies with the following Community Directives: - 73/23/EEC of 19/02/73 (Low Voltage) and subsequent amendments; -89/336/EEC of 03. The European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE), requires that old household electrical appliances must not be disposed of in the normal unsorted municipal waste stream. Old appliances must be collected separately in order to optimise the recovery and recycling of the materials they contain and reduce the impact on human health and the environment. The crossed out wheeled bin symbol on the product reminds you of your obligation, that when you dispose of the appliance it must be separately collected. Consumers should contact their local authority or retailer for information concerning the correct disposal of their old appliance. The appliance was designed for domestic use inside the home and is not intended for commercial or industrial use. [. . . ] the thickness of the frost exceeds 2-3 mm (see Maintenance). The appliance has not been installed on a level surface (see Installation). The appliance has been installed between cabinets that vibrate and make noise. The internal refrigerant makes a slight noise even when the compressor is off. [. . . ]