User manual INDESIT RG 1140

[. . . ] Ensure that the cable is not trapped or damaged during the installation. Never pull the cable or the appliance to remove the plug from the socket. Do not touch the internal cooling elements, especially if your hands are wet, since you could burn or hurt yourself. [. . . ] THE FOLLOWING OPERATIONS SHOULD BE CARRIED OUT BY A QUALIFIED ELECTRICIAN. If a 13 amp plug (BS 1363) is used it must be fitted with a 13 amp fuse. A 15 amp plug must be protected by a 15 amp fuse, either in the plug or adaptor or at the distribution board. If you are in any doubt about the electrical supply to your machine, consult a qualified electrician before use. How to connect an alternative plug: The wires in this mains lead are coloured in accordance with the following code: BLUE "NEUTRAL" ("N") BROWN "LIVE" ("L") GREEN AND YELLOW "EARTH" ("E") Replacing the fuse: When replacing a faulty fuse, a 13 amp ASTA approved fuse to BS 1362 should always be used, and the fuse cover refitted. If the fuse cover is lost, the plug must not be used until a replacement is obtained. Replacement fuse covers: If a replacement fuse cover is fitted, it must be of the correct colour as indicated by the coloured marking or the colour that is embossed in words on the base of the plug. Replacements can be obtained directly from your nearest Service Depot. GREEN & YELLOW BROWN 13 ampere fuse BLUE CROSS-BAR CORD GRIP Removing the plug: If your appliance has a non-rewireable moulded plug and you should wish to remove it to add a cable extension or to re-route the mains cable through partitions, units etc. , please ensure that either: - the plug is replaced by a fused 13 amp re-wireable plug bearing the BSI mark of approval or: - the mains cable is wired directly into a 13 amp cable outlet, controlled by a switch, (in compliance with BS 5733) which is accessible without moving the appliance. Disposing of the appliance: When disposing of the appliance please remove the plug by cutting the mains cable as close as possible to the plug body and dispose of it as described above. Disposing of the plug: Ensure that before disposing of the plug itself, you make the pins unusable so that it cannot be accidentally inserted into a socket. Instructions for connecting cable to an alternative plug: Important: the wires in the mains lead are coloured in accordance with the following code: Green & Yellow - Earth Blue - Neutral Brown - Live As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: Connect Green & Yellow wire to terminal marked "E" or or coloured Green or Green & Yellow. Connect Brown wire to terminal marked "L" or coloured Red. Connect Blue wire to terminal marked "N" or coloured Black. GB 2 A closer look Temperature regulation knob Use this knob to regulate the temperature of the refrigerator. The following settings are available: refrigerator OFF; 1 minimum cold temperature; 5 maximum cold temperature Adjustable Feet Fruit and Vegetable Srawer Removable, Height-adjustable Shelves You can position the knob on any of the settings from 1 - 5 as required. Remember that you can turn off your refrigerator by setting the knob to . A Door Shelf with Egg Compartment Door Shelf for Food Products B Door Shelf for Bottles G C F D E A B G C H D E 3 GB Setting up Your Appliance ATTENTION After transport stand the appliance upright and wait at least 3 hours before plugging the appliance into the mains to ensure proper performance. Use these average temperature settings to ensure optimum performance and to save energy. Before storing food in your refrigerator wipe the interior with a solution of warm water and bicarbonate of soda. After having plugged the appliance into the socket, make sure that the refrigerator light has turned on. Then turn the thermostat knob "A" to setting "3". [. . . ] If you do not have any sodium bicarbonate at home, use a neutral soap. - What not to use: Do not use abrasive detergents, bleach or detergents containing ammonia. - All removable parts can be cleaned by soaking them in hot soapy water or detergent. [. . . ]