User manual INDESIT RG 1142

[. . . ] Before doing any cleaning, disconnect the appliance from the electricity (by pulling out the plug orturning off the general switch in your home); it is not sufficient to place the temperature regulation knob on to cut off the power. Before disposing of your old appliance, remember to break or remove the lock as a safety measure to protect children who might lock themselves inside the appliance when playing. If your appliance is not operating properly, before calling your after-sales service read the chapter on "Trouble Shooting" which might help you resolve the problem. Do not attempt to repair the fault by intervening on the internal components. [. . . ] If damaged, the power supply cord on this appliance must necessarily be replaced by our service centre because special tools are required for replacement. Installation To ensure that the appliance operates properly and to reduce energy consumption, it is important that the appliance is installed correctly. Electrical Connection and Earthing Before proceeding with the electrical connection, make sure that the voltage indicated on the rating plate, located at the bottom left near the vegetable crisper, corresponds to the mains voltage in your home and that the socket is fitted with a standard earthing wire in accordance with safety standards for 46/90 systems. If the socket is not fitted with an earthing wire, the manufacturer will not be held liability for any damages and or injuries arising out of the use of the appliance. Do not use multiple sockets or adapters. Ventilation The compressor and condenser generate heat and, therefore, need to be ventilated properly. Rooms with less than perfect ventilation are not very suited for installation of the appliance. Therefore, it should be installed in a room with an opening (window or French window) that provide the appropriate amount of air re-circulation. It is also important that the room not be too humid. During installation, make sure not to cover or obstruct the grates that allow for proper ventilation of the appliance. For proper ventilation of the appliance, you must leave: - a space of at least 10 cm between the top part and any cabinets above it; - a space of at least 5 cm between the sides of the appliance and any adjacent cabinets/walls. Insufficient power? The electrical socket must be able to handle the maximum power load of the appliance, which is indicated on the rating plate located at the bottom left next to the vegetable crisper. Before making the electrical connection . . . After the appliance has been delivered, place it in the vertical upright position and wait at least 3 hours before inserting the plug into the socket in order to ensure that it functions properly. Away from Heat Avoid positioning the appliance in a place where it is directly exposed to sunlight or near an oven, cook top or the like. Level The appliance must be level. If the floor is not level, the adjustable foot located in front can be used to level the appliance. 1 GB Electrical connection Your appliance is now supplied with a 13 amp fused plug that can be plugged into a 13 amp socket for immediate use. Before using the appliance please read the instructions below. WARNING - THIS APPLIANCE MUST BE EARTHED. - Contrary to popular belief, cooked foods do not keep longer than fresh food. - Do not store liquids in unsealed containers since this will increase the humidity and lead to the formation of frost in the refrigerator. GB 4 Energy Saving Tips - Install the Appliance Correctly This means that the appliance should be installed away from heat sources or direct sunlight in a well ventilated room. - Keep the Door Closed Open the refrigerator only when necessary; remember that every time you open the door most of the cold air will be lost. To bring the temperature back to the proper level, the motor must run for a considerable amount of time, consuming a substantial amount of energy. - Correct Temperature Settings Set the refrigerator temperature knob to one of the middle settings. Very cold temperature settings will not only consume a great deal of energy but will neither improve nor lengthen the storage life of the food. Excessively cold temperatures may ruin vegetables, cold cuts and cheese. - Check the Seal on the Door Keep the seal clean and soft so that it fits tightly against the door to ensure that no cold air is lost. - Do Not Overfill Your Appliance Remember that proper storage of food requires good air circulation. Overfilling your appliance will hamper proper air circulation and overwork the compressor. - Never Put Food in the Refrigeror while Still Hot A container of hot food in the refrigerator will increase the temperature significantly; allow food to cool to room temperature before storing. Caring for Your Appliance Before doing any cleaning, disconnect the appliance from the electricity (by pulling out the plug or turning off the general switch in your home). Cleaning and Maintenance - Your appliance is manufactured with hygienic, odourless materials. To preserve these characteristics, always use sealed containers to store foods in order to prevent spills, stains and the formation of difficult to remove odours. - Only use a water and bicarbonate solution to clean the applianc. Clean the internal and exterior of your appliance with a sponge soaked in a warm water and sodium bicarbonate solution, which is also a good disinfectant. If you do not have any sodium bicarbonate at home, use a neutral soap. - What not to use: Do not use abrasive detergents, bleach or detergents containing ammonia. [. . . ] If you do not have any sodium bicarbonate at home, use a neutral soap. - What not to use: Do not use abrasive detergents, bleach or detergents containing ammonia. - All removable parts can be cleaned by soaking them in hot soapy water or detergent. Remember to dry them thoroughly before replacing them. [. . . ]