User manual INDESIT SIXL145D

[. . . ] - modello - model - modèle - modell - model - modelo - modelo - model - model - model - modell - model - numero di serie - serial number - numéro de série - modellnummer - serienummer - número de serie - número de série - numer seryjny - număr de serie - výrobní číslo - sorozatszám - výrobné číslo 4 Kundendienst Bevor Sie sich an den Kundendienst wenden: • Prüfen Sie, ob die Störung selbst behoben werden kann (siehe Störungen und Abhilfe). U moet doorgeven: • het type storing • het model apparaat (Mod. ESTAMOS A SU SERVICIO - modello - model - modèle - modell - model - modelo - modelo - model - model - model - modell - model - numero di serie - serial number - numéro de série - modellnummer - serienummer - número de serie - número de série - numer seryjny - număr de serie - výrobní číslo - sorozatszám - výrobné číslo 5 Assistência Antes de contactar a Assistência técnica: • Verifique se pode resolver sozinho a anomalia (veja as Anomalias e Soluções). - modello - model - modèle - modell - model - modelo - modelo - model - model - model - modell - model - numero di serie - serial number - numéro de série - modellnummer - serienummer - número de serie - número de série - numer seryjny - număr de serie - výrobní číslo - sorozatszám - výrobné číslo 6 Mielőtt szerelőhöz fordulna: • Ellenőrizze, hogy a hibát nem tudja-e elhárítani (lásd Hibaelhárítás). [. . . ] Furthermore, the special fastening system makes Easy Ice an extremely flexible solution, as it can be positioned in the right or left part of the top drawers. Pure Wind maximises air circulation, improving the efficiency of the evaporator and helping to achieve the optimal temperature inside the refrigerator as quickly as possible each time it has been opened. The blown air (A) is cooled when it comes into contact with the cold wall, whereas the hotter air (B) is sucked up (see diagram). Static Models without the Aircooler have the cooling section in the internal back wall of the compartments. The wall will be covered in frost or water droplets depending on whether the compressor is operating or paused: both cases are normal. If the TEMPERATURE ADJUSTMENT knob has been set on high values with large quantities of food and with a high ambient temperature, the appliance can operate continuously, resulting in excessive frost formation and excessive energy consumption: compensate for this by shifting the knob towards lower values (defrosting will occur automatically). In static appliances, the air circulates in a natural way: the colder air tends to move downwards as it is heavier. The food should be stored as follows: Food Fresh fish and meat Fresh cheese Cooked food Salami, loaves of bread, On any shelf chocolate In the fruit and vegetable Fruit and vegetables compartment bins Eggs On the shelf provided Butter and margarine Bottles, drinks, milk On the shelf provided On the shelves provided Arrangement inside the refrigerator Above the fruit and vegetable bins Above the fruit and vegetable bins On any shelf Using the refrigerator to its full potential • Use the TEMPERATURE ADJUSTMENT knob to adjust the temperature (see Description). € Place only cold or lukewarm foods in the compartment, not hot foods (see Precautions and tips). € Remember that cooked foods do not last longer than raw foods. • Do not store liquids in open containers. If there is a power cut or malfunction, do not open the freezer door. This will help maintain the temperature inside the freezer, ensuring that foods are conserved for at least 9 -14 hours. If the room temperature drops below 14°C for an extended period of time, the ideal temperature will not be reached in the freezer compartment and food preservation will be reduced. GB Defrosting the freezer compartment If the frost layer is greater than 5 mm, it is necessary to defrost manually: 1. Set the TEMPERATURE ADJUSTMENT knob to the position OFF 2. Wrap frozen foods in newspaper and place them in another freezer or in a cool place. Leave the door open until the frost has melted completely. This can be made easier by placing containers with lukewarm water in the freezer compartment. Clean and dry the freezer compartment carefully before switching the appliance on again. Certain appliances are fitted with the DRAIN SYSTEM to lead the water outside: let the water flow into a container (see diagram). Maintenance and care Switching the appliance off During cleaning and maintenance it is necessary to disconnect the appliance from the electricity supply. [. . . ] € Do not touch the appliance with bare feet or with wet or moist hands and feet. € Do not touch the internal cooling elements: this could cause skin abrasions or frost/freezer burns. € When unplugging the appliance always pull the plug from the mains socket, do not pull on the cable. € Before cleaning and maintenance, always switch off the appliance and disconnect it from the electrical supply. [. . . ]