User manual INDESIT THP 751 W/IX/I IT

[. . . ] Operating Instructions, 1 Warnings, 2 Assistance, 3 Description of the appliance, 4 Installation, 5 Start-up and use, 8 Precautions and tips, 8 Maintenance and care, 9 Troubleshooting, 9 Product Guarantee and Repair Information, 10 WARNING: The appliance and its accessible parts become hot during use. Care should be taken to avoid touching heating elements. Children less than 8 years of age shall be kept away unless continuously supervised. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. [. . . ] Sticker are available from any of our Service Centres. Once the appliance has been installed, the power supply cable and the · Electrical socket must be easily accessible. The cable must not be bent or compressed. The cable must be checked regularly and replaced by authorised technicians only (see Assistance). The manufacturer declines any liability should these safety measures not be observed. This operation must be performed by a qualified technician. Setting the burners to minimum To ensure that the minimum setting is correctly adjusted, remove the knob and proceed as follows: 1. Adjust the adjustment screw, which is positioned in or next to the tap pin, until the flame is small but steady: · Tighten screw to reduce the flame height; · Loosen screw to increase the flame height; The adjustment must be performed with the tap in minimum gas setting position. The appliance should be connected to the main gas supply or to a gas cylinder in compliance with current national regulations. Before carrying out the connection, make sure the cooker is compatible with the gas supply you wish to use. If this is not the case, follow the instructions indicated in the paragraph "Adapting to different types of gas. " When using liquid gas from a cylinder, install a pressure regulator which complies with current national regulations. Check that the pressure of the gas supply is consistent with the values indicated in Table 1 ("Burner and nozzle specifications"). This will ensure the safe operation and longevity of your appliance while maintaining efficient energy consumption. The connection of the hob to the gas pipe network or gas cylinder must be made by means of a rigid copper or steel pipe with fittings complying with local regulations, or by means of a continuous-surface stainless steel hose complying with local regulations. interpose gasket (B) in the elbow connection. FOR BELGIUM ONLY: It is necessary to replace the elbow connection (A) on the appliance, with the one supplied (if present). IMPORTANT: if a stainless steel hose is used, it must be installed so as not to touch any mobile part of the furniture. It must pass through an area where there are no obstructions and where it is possible to inspect it on all its length. Having adjusted the flame to the required low setting, while the burner is alight, quickly change the position of the knob from minimum to maximum and vice versa several times, checking that the flame does not go out. Some appliances have a safety device (thermocouple) fitted. If the device fails to work when the burners are set to the low flame setting, increase this low flame setting using the adjusting screw. [. . . ] This procedure must be performed by a qualified technician authorised by the manufacturer. troubleshooting It may happen that the appliance does not function properly or at all. Calling the service centre for assistance, check if anything can be done. Check to see that there are no interruptions in the gas and electrical supplies, And, in particular, that the gas valves for the mains are open. [. . . ]