User manual INDESIT WD12X

[. . . ] That the inlet and draining pipes are connected correctly. Never use pipes that have already been used. That the washer-dryer is levelled properly; something worth checking to aid the performance of your washer-dryer; 4. That the drum's fixing screws have been removed from the back of the washer-dryer; 2. [. . . ] If it is, then a programmed start has been set. Is the programmed start knob, in the correct position for those models concerned?For safety reasons, if the washer-dryer does not load water, it cannot start a wash cycle. off, select one of the symbols stop/reset , then switch it back on. If the knob continues to turn, call for assistance because it is showing an anomaly. But where did all the water go? Simple: with the new Indesit technology, you need less than half of it, to get good results on twice as much!This is why you cannot see the water through the door: because there is little, very little of it, to respect the environment yet without renouncing maximum cleanliness. And, on top of that, you are also saving electricity. The washer-dryer fails to fill with water. RIGHT Turn off the water supply after use. This will eliminate the possibility of leakage. Always leave the appliance door ajar to avoid bad odours. Clean the appliance’s exteriors gently. To clean the exteriors and the rubber parts of the appliance, always use a soft cloth dipped in warm and soapy water. WRONG Leave the washer-dryer plugged in while cleaning. The tract of the drain hose must be as straight as possible. Make sure the drain hose is not squashed or kinked. Too much foam. Is the detergent appropriate for machine washing?Check whether the definition on its label reads “for machine wash” or “hand and machine wash”, or any other similar wording. Excessive vibration during the spin cycle. The washer-dryer leaks. Have all transit screws been removed durind installation?See the following page on installation procedures. Has the washer-dryer been levelled correctly?The levelling of the appliance should be checked periodically. Adjust the feet and check them with a level. Is the metal ring of the inlet hose properly attached?Turn off the water supply, unplug the appliance and try tightening its attachment without forcing it. Turn off the water supply, unplug the appliance and try tightening its attachment. Is the correct amount being used? [. . . ] The power supply cable must never be bent or dangerously compressed. I only want an authorised specialised technician with original Indesit spare parts! Your washer-dryer has been built in compliance with the strictest international safety regulations. Never pull on the supply cable or the washer-dryer to disconnect it from the wall socket: it is extremely dangerous. While the appliance is functioning, do not touch the drain water as it could reach very high temperatures. The appliance door, during wash cycles, tends to become hot; ensure that children do no touch it. [. . . ]