User manual INDESIT WDG1295

[. . . ] q If you are going to install the Minimum gap 10mm appliance under a work counter, be sure to leave a 10mm space between the top and any other objects on or above the machine and a 15mm space between the Minimum gaps 15mm sides and lateral furnishings or walls. This is to ensure proper air circulation. Make sure that the back vents are not obstructed. q Make sure you put your dryer in an environment that is not damp and has proper air circulation throughout, the dryer will not operate efficiently in an enclosed space or cupboard. q Permanent venting In conjunction with the vent tube we recommend using a Wall/Window Vent Kit, available at a retail location or the nearest Spare Parts Dealer. [. . . ] This programme can also be used for large loads if you require a slightly drier result. If you select LOW HEAT, this programme will not dry your clothes. For Acrylic fibres or small loads select Timed Drying. This programme can also be used for average loads if you prefer a damper result. B Automatic Drying (average loads) A Automatic Drying (large loads) 1. Select HIGH HEAT by pressing Dries completely: the HEAT button. Cotton . Easy Iron by pressing Brief programme (approximately 1. 10 minutes) that softens fibres of clothing that is ready for ironing. Select required heat setting HIGH HEAT or LOW HEAT by pressing the HEAT button. Position the PROGRAMMES knob on the desired time. This is not a drying programme (see below). Timed Drying Dries wet clothes that will be , or up to 120 minutes ironed, Acrylic fibres small loads (less than 1kg). Consult suggested drying times (see Laundry). Cool Tumble Phase Heating elements turn themselves off and clothing is cooled down. This is the programmes final phase. Always allow the dryer to Approximately 10 minutes before the complete this phase. Pleated or creased garments: read the manufacturer's drying instructions on the garment. Starched articles: do not dry these with non-starched items. Make sure that as much of the starch solution is removed from the load as possible before placing it in the dryer. Do not over-dry: the starch will become powdery and leave your clothing limp, which defeats the purpose of starch. Times are approximate and can vary depending upon: q Amount of water retained in clothes after spin cycle: towels and delicates retain a lot of water. Fabrics: items that are the same type of fabric but different textures and thicknesses may not have the same drying time. After using the dryer, turn it off and unplug it. Keep the door closed to make sure that children do not use it as a toy. The appliance must be installed correctly and have proper ventilation. The air intake vents behind the machine, the outlet vents and the vent tube should never be obstructed (see Installation). Never direct the vent tube outlet towards the air intake at the back of the machine. Never allow the tumble dryer to recycle exhaust air. [. . . ] A coloured film may start to appear on the stainless steel drum, this may be caused by a combination of water and, or cleaning agents such as fabric conditioner from the wash. This coloured film will not affect the dryer performance. Cleaning q External parts in metal or plastic and rubber parts can be cleaned with a damp cloth. Periodically check the vent tube and any permanent venting fixture to make sure that there has been no accumulation of fluff or lint, and remove it. Remove lint that collects around the filter and the outlet vents. q q Removing the filter: 1. [. . . ]