User manual INDESIT WIL144SP

[. . . ] If the installation instruction manual for the gas cooking appliance specifies a greater distance, this measurement should be taken into account. €¢ The cooker hood comes with anchor plugs which are suitable for use with most walls/ceilings. However, you must contact a qualified technician to check the suitability of the materials in relation to the type of wall/ ceiling, which must be strong enough to support the weight of the unit. Do not hook the unit up to its electrical power supply until the installation has been completed. [. . . ] The manufacturer is not liable for any consequences of doing so. Use the shortest duct required to achieve the purpose. Use a duct with as few bends as possible !Avoid suddenly changing the diameter of the duct. The duct must have as smooth an inner surface as possible. The duct must be made of regulatory material. Do not connect the hood to flues carrying combustion fumes from other equipment (boilers, chimneys, stoves, etc. Observe the instructions of the competent authorities in relation to the air exhaust. The air being exhausted may not be exhausted into a wall cavity unless the cavity in question is specifically intended for this purpose. Equip the room with air intakes to prevent the hood creating suction pressure in the interior (this must not exceed 0. The manufacturer is not liable for any consequences of failure to observe these instructions. 5S CD X/HA HPS 60 IX/HA B To reset the filter counter: Hold down T4 for three seconds while the hood is on. If both filter warnings are active at the same time, you must reset each separately. The first sequence resets the grease filter, while the second sequence resets the odour filter. Configuring the hood To set the operating mode of the hood, hold down T4 for 6 seconds. After a long beep, the type of installation displays: Ducted (square at bottom left flashing). GB T1 T2 T3 T4 T5 T6 1 Motor ON/OFF Press the button with the hood off to set speed 1. Pressing the button while the hood is in operation turns it OFF. T2 Speed Pressing the button returns the hood to the previous speed. T3 Speed + Pressing the button returns the hood to the next speed. If the hood is off, pressing these buttons sets speed 1. T4 Booster Pressing this button sets the hood to high speed; the letter "b" flashes slowly on the display. [. . . ] The bar at the top right flashes to indicate that the odour filter is saturated. If both bars are flashing, then both filters are saturated. You must then clean/replace the grease filter (A) or odour filter (B) or both, accordingly (see “Maintenance and care”). The latter only applies to the filter version. [. . . ]