User manual INDESIT WIXXE167S

[. . . ] Q Minimum gap 10mm If you are going to install the appliance under a work counter, be sure to leave a 10mm space between the Minimum gaps top and any other objects 15mm on or above the machine and a 15mm space between the sides and lateral furnishings or walls. This is to ensure proper air circulation. Make sure that the back vents are not obstructed. If your dryer is installed next to a drain the water can be plumbed into this drain. [. . . ] Warning, if after pressing the start button, the programmes knob position is changed, the new position will NOT change the programme selected. These buttons are used to customise the selected programme to your requirements. A programme must have been selected on the programme knob before an option can be selected. Not all options are available for all programmes (see Start and Programmes). If an option is not available and you press the button, the buzzer will beep four times. If the option is available there will be one beep and the option light above the button lights to confirm the selection. After the start button has been pressed only the Alarm option can be changed. Progress ( Drying, CoolTumble, Post Creasecare) / Delay (3hr 6hr 9hr 12hr) Lights When the light above the delay button is on, these lights flash to indicate the delay time is selected. During other programmes they indicate the progress of the dryer, each one comes on as the corresponding phase starts. Time Delay The start of some programmes (see Start and Programmes) can be delayed for up to 12 hours in 3hr steps. Ensure the water bottle is emptied before setting a delayed start. You can use this to select the Cool Tumble programme to cool the clothes, if you find them dry enough. Note If you have a power cut, switch off the power or remove the plug, press the START button and the programme will resume. Check symbols on clothing labels to make sure that the articles can be tumble dried. Q Wring out each item in order to eliminate as much excess water as possible. Do not load dripping wet clothes into the dryer. Wash Care Labels Look at the labels on your garments, especially when tumble drying for the first time. The following symbols are the most common: May be tumble dried Do not tumble dry Tumble dry at high heat setting Tumble dry at low heat setting Maximum load size Do not load more than maximum capacity. These numbers refer to dry weight: Natural fibres: 7kg max (15lb) Synthetic fibres: 3kg max (6. Articles that containing rubber or rubber-like materials or plastic film (pillows, cushions, or PVC rainwear), any other flammable articles or objects that contain flammable substances (towels soiled with hair spray). Glass fibres (certain types of draperies) Items which have been dry cleaned Items with the ITCL Code (see Special clothing items). These can be cleaned with special at-home dry cleaning products. [. . . ] Turn the drum manually in order to remove small items (handkerchiefs) that could have been left behind. Front Condenser unit Condenser cover Catches One day your dryer seems not to be working. Before you call your Service Centre (see Service), go through the following troubleshooting suggestions: The plug is not plugged into the socket, or not making contact. Try to plug another appliance into the socket. [. . . ]