User manual INDESIT XWDA 751480X W FR

[. . . ] 2 Raccordement du tuyau de vidange Raccorder le tuyau d’évacuation, sans le plier, à un conduit d’évacuation ou à une évacuation murale placés à une distance du sol comprise entre 65 et 100 cm ; ou bien l’accrocher à un évier ou à une baignoire, dans ce cas, fixer le support en plastique fourni avec l’appareil au robinet (voir figure). This symbol reminds you to read this instruction manual. GB English GB Contents Installation, 14-15 Unpacking and levelling Connecting the electricity and water supplies The first wash cycle Technical data Care and maintenance, 16 Cutting off the water or electricity supply Cleaning the Washer-dryerCleaning the detergent dispenser drawer Caring for the door and drum of your appliance Cleaning the pump Checking the water inlet hose XWDA 751480 Precautions and tips, 17 General safety Load balancing system Disposal Description of the Washer-dryer and starting a wash cycle, 18-19 Control panel Indicator lights Starting a wash cycle Wash cycles, 20 Push&Wash+Dry Table of wash cycles Personalisation, 21 Setting the temperature Setting the drying cycle Wash options Detergents and laundry, 22 Detergent dispenser drawer Bleach cycle Preparing the laundry Garments requiring special care Troubleshooting, 23 Service, 24 13 Installation GB !This instruction manual should be kept in a safe place for future reference. [. . . ] The door can be opened once the DOOR LOCK indicator light turns off (wait approximately 3 minutes). Take out your laundry and leave the appliance door ajar to make sure the drum dries completely. Switch the Washer-dryer off by pressing the ON/OFF button. 19 Wash cycles GB Push&Wash+Dry This function makes it possible to start an automatic wash and drying cycle either when the machine is off without having to press the ON/OFF button in advance, or after switching on the machine without having activated any button and/or selector (otherwise the Push&Wash+Dry function will be deactivated). To start the Push&Wash+Dry cycle press and hold the button for 2 seconds. The indicator lights up to show that the cycle has started. The wash and drying cycle is ideal for cotton or synthetic fabrics, as it washes them at a temperature of 30° and a maximum spin speed of 1000 rpm. During the drying cycle the maximum temperature is 60°C. At the end of the cycle the residual humidity will be the same as for the “ ” level. Load the laundry (cotton and/or synthetic garments) and close the door. Start the cycle by pressing and holding the Push&Wash+Dry button for 2 seconds. The relevant indicator light will turn green and the door will lock (the DOOR LOCKED symbol is lit). NB: starting the cycle through the Push&Wash+Dry button activates an automatic non-customisable wash and drying cycle recommended for cotton and synthetic fabrics. The automatic cycle can be used only for washing, excluding the drying phase. Press the Push&Wash+Dry button and then the drying button : the drying icon of the “ ” level will switch off. maximum load for washing-only is 3 , 5 kg (Cycle duration 50’). To open the door while an automatic cycle is under way, press the START/PAUSE button. If the DOOR LOCKED symbol is off, the door may be opened only during the washing phase. Press the START/PAUSE button again to restart the wash cycle from the point at which it was interrupted. Once the programme is finished, the FIN indicator light turns on. Table of wash cycles Wash cycles Description of the wash cycle Prewash Max. Speed (rpm) Duration of wash cycle Detergents Fabric softener Bleach Wash Maximum load for washing (Kg) Maximum load for drying (Kg) Drying Special 1 2 3 3 4 5 6 Sport Dark Anti-odour (Cotton) Anti-odour (Synthetic) Delicate Wool: for wool, cashmere, etc. [. . . ] € The free end of the hose is under water (see “Installation”). € The wall drainage system is not fitted with a breather pipe. If the problem persists even after these checks, turn off the water tap, switch the appliance off and contact the Assistance Service. If the dwelling is on one of the upper floors of a building, there may be problems relating to water drainage, causing the Washer-dryer to fill with water and drain continuously. [. . . ]