User manual INDESIT XWDE 861480X W

[. . . ] This symbol reminds you to read this instruction manual. GB GB English Contents Installation, 16-17 Unpacking and levelling Connecting the electricity and water supplies The first wash cycle Technical data Care and maintenance, 18 Cutting off the water and electricity supplies Cleaning the washer-dryer Cleaning the detergent dispenser drawer Caring for the door and drum of your appliance Cleaning the pump Checking the water inlet hose XWDE 861480 Precautions and tips, 19 General safety Disposal Opening the porthole door manually Description of the washer-dryer, 20-21 Control panel Display How to run a wash cycle or a drying cycle, 22 Wash cycles and options, 23-24 Table of wash cycles Wash options Push&Wash+Dry Detergents and laundry, 25-26 Detergent dispenser drawer Bleach cycle Preparing the laundry Special wash cycles Load balancing system Troubleshooting, 27 Service, 28 15 Installation GB !This instruction manual should be kept in a safe place for future reference. If the washerdryer is sold, transferred or moved, make sure that the instruction manual remains with the machine so that the new owner is able to familiarise himself/herself with its operation and features. [. . . ] The machine automatically displays the maximum temperature and spin speed values set for the selected cycle, or the most recently-used settings if they are compatible with the selected cycle. The temperature can be decreased by pressing the button, until the cold wash “OFF” setting is reached. The spin speed may be progressively reduced by pressing the button, until it is completely excluded (the “OFF” setting). If these buttons are pressed again, the maximum values are restored. Exception: if the 8 programme is selected, the temperature can be increased up to a value of 90°C. Setting the drying cyclea The first time the button is pressed, the machine will automatically select the maximum drying cycle which is compatible with the selected wash cycle. Subsequent presses will decrease the drying level and then the drying time, until the cycle is excluded completely (“OFF”). Drying may be set as follows: A- Based on the desired laundry dryness level: Cupboard : suitable for laundry which can be put back in a cupboard without being ironed. Hanger : ideal for clothes which do not need to be dried fully. Iron : suitable for clothes which will need ironing afterwards. The remaining dampness softens creases, making them easier to remove. B - Based on a set time period: between 210 and 30 minutes 22 If your laundry load to be washed and dried is much greater than the maximum stated load (see adjacent table of wash cycles), perform the wash cycle, and when the cycle is complete, divide the garments into groups and put some of them back in the drum. At this point, follow the instructions provided for a “Drying only” cycle. Repeat this procedure for the remainder of the load. Note: a cooling-down period is always added to the end of each drying cycle. Drying only Press button to perform the drying-only cycle. After selecting the desired cycle (compatible with the type of garments), press button to exclude the washing phase and start the drying phase at the maximum level for the selected cycle. The drying level or time may be set and changed by pressing the drying button . To set a delayed start for the selected cycle, press the corresponding button repeatedly until the required delay period has been reached. When this option has been activated, the symbol lights up on the display. To remove the delayed start setting, press the button until the text “OFF” appears on the display. €¢ Press the button to enable the option; the indicator light corresponding to the button will switch on. [. . . ] If the dwelling is on one of the upper floors of a building, there may be problems relating to water drainage, causing the washer-dryer to fill with water and drain continuously. Special antidraining valves are available in shops and help to prevent this inconvenience. €¢ The wash cycle does not include draining: some cycles require the draining process to be enabled manually. €¢ The drum was not unlocked correctly during installation (see “Installation”). [. . . ]