User manual INDESIT XWE 71452 WSG FR

[. . . ] 14 Instructions for use WASHING MACHINE Contents GB English GB Installation, 16-17 Unpacking and levelling Connecting the electricity and water supplies The first wash cycle Technical data Care and maintenance, 18 Cutting off the water and electricity supplies Cleaning the washing machine Cleaning the detergent dispenser drawer Caring for the door and drum of your appliance Cleaning the pump Checking the water inlet hose Precautions and tips, 19 General safety Disposal Opening the porthole door manually XWE 71452 Description of the washing machine, 20-21 Control panel Display Running a wash cycle, 22 Wash cycles and options, 23-24 Table of wash cycles Wash options Push & Wash Detergents and laundry, 25-26 Detergent dispenser drawer Bleach cycle Preparing the laundry Special wash cycles Load balancing system Troubleshooting, 27 Service, 28 15 Installation GB !This instruction manual should be kept in a safe place for future reference. If the washing machine is sold, transferred or moved, make sure that the instruction manual remains with the machine so that the new owner is able to familiarise himself/ herself with its operation and features. Read these instructions carefully: they contain vital information relating to the safe installation and operation of the appliance. [. . . ] To remove the delayed start setting, press the button until the text “OFF” appears on the display. €¢ Press the button to enable the option; the indicator light corresponding to the button will switch on. €¢ Press the button again to disable the option; the indicator light will switch off. If the selected option is not compatible with the set wash cycle, the indicator light will flash and the option will not be activated. If the selected option is not compatible with another previously selected option, the indicator light will flash accompanied by a buzzer (3 beeps), and only the latter option will be activated; the indicator light corresponding to the activated option will turn on. The options may affect the recommended load value and/or the duration of the cycle. The corresponding indicator light will turn green, remaining lit in a fixed manner, and the door will be locked (the DOOR LOCKED symbol will be lit). To change a wash cycle while it is in progress, pause the washing machine using the START/PAUSE button (the START/PAUSE indicator light will flash slowly in an amber colour); then select the desired cycle and press the START/PAUSE button again. To open the door while a cycle is in progress, press the START/PAUSE button; if the DOOR LOCKED symbol is switched off the door may be opened. Press the START/PAUSE button again to restart the wash cycle from the point at which it was interrupted. This will be indicated by the text “END” on the display; when the DOOR LOCKED symbol switches off the door may be opened. Open the door, unload the laundry and switch off the machine. If you wish to cancel a cycle which has already begun, press and hold the button. The cycle will be stopped and the machine will switch off. 22 Wash cycles and options Table of wash cycles Wash cycles Detergents Fabric softener Bleach Wash Description of the wash cycle Prewash Max. Load (kg) Total water lt Residual dampness % Energy consumption kWh GB Special Sport Dark Anti-odour (Cotton) Anti-odour (Synthetic) Delicate Wool: for wool, cashmere, etc. 20° Eco Synthetic 20° Rapid Rapid 30° Rapid 60° Partials Rinse/Bleach Spin + Drain Drain only * and exclude the spin cycle, the machine will drain only. 53 2, 15 53 46 46 53 80 1, 00 0, 79 0, 56 0, 89 0, 22 - 86 170’ 75 46 46 70 170’ 110’ 100’ 100’ 53 1, 07 52, 5 180’ - 170’ - 120’ 9’ 34 30’ 60’ 50’ 10’ 3’ * If you select programme The length of cycle shown on the display or in this booklet is an estimation only and is calculated assuming standard working conditions. The actual duration can vary according to factors such as water temperature and pressure, the amount of detergent used, the amount and type of load inserted, load balancing and any wash options selected. 1) Test wash cycle in compliance with directive 1061/2010: set wash cycle 8 with a temperature of 60°C. This cycle is designed for cotton loads with a normal soil level and is the most efficient in terms of both electricity and water consumption; it should be used for garments which can be washed at 60°C. The actual washing temperature may differ from the indicated value. [. . . ] €¢ The wall drainage system is not fitted with a breather pipe. If the problem persists even after these checks, turn off the water tap, switch the appliance off and contact the Technical Assistance Service. If the dwelling is on one of the upper floors of a building, there may be problems relating to water drainage, causing the washing machine to fill with water and drain continuously. Special antidraining valves are available in shops and help to prevent this inconvenience. [. . . ]