User manual INFINITY 2100M

[. . . ] ® MARINE ¨ off auto on 6100m , 6000m , 2100m wakeboard tower sound system instructions Thank you Infinity would like to take this opportunity to thank you for purchasing one of our products. In order that we may better serve you should you require warranty service, please retain your original purchase receipt. If you would like to register your product, please visit our Web site at www. infinitysystems. com. INTRODUCTION WARNING!Loud music can cause permanent damage to your hearing. [. . . ] Run the wires along the tube and secure in place with plastic zip ties. If the tube has wire holes available, run the speaker wires through the tower tubes to the amplifier. Check to make sure the wires will not come in contact with sharp edges or metal that can damage the wires over time. NOTE: The connectors are keyed to line up properly. Check for proper alignment before connecting. Swiveling the speaker. 3 MOUNTING THE AMPLIFIER Mount the 6100m or 2100m amplifier in a location that is away from direct contact with water, whether from washing, big waves or soggy riders. Choose a location in the boat where the amplifier will not be damaged by shifting cargo or passengers. If the amplifier is going to be under a seat, ensure that it is clear of all moving parts and will not affect the seat adjustments. If mounting the amplifier in an enclosed space, make sure there is plenty of air circulation for the amplifier to cool properly. POWER CONNECTIONS The 6100m/2100m amplifiers are capable of delivering high power levels, and require a reliable connection to the boat's electrical system in order to perform optimally. Please adhere to the following instructions carefully: GND TERMINAL Connect the amplifier's Ground (GND) terminal directly to the boat's negative (­) battery terminal using a minimum of 8-gauge power wire. +12V TERMINAL Connect a minimum of 8-gauge power wire directly to the boat's positive battery terminal, and install an appropriate fuse holder within 18" of the battery terminal. Route the wire to the amplifier's location, and connect it to the amplifier's positive (+12V) terminal. Be sure to use appropriate grommets whenever routing wires through panels. Failure to adequately protect the positive wire from potential damage may result in a fire. When you are done routing and connecting this wire, you may install the fuse at the battery. NOTE: If your boat uses a multiple battery setup, please contact the boat manufacturer or dealer for proper connection instructions. REMOTE TERMINAL Connect the amplifier's REMOTE terminal to the source unit's Remote Turn-On lead, using a minimum of 18-gauge wire. If your source unit does not have a remote turn-on connection, connect the amplifier's REMOTE terminal to the boat's accessory circuit. NOTE: When using the Hi-level inputs, connect the REMOTE terminal to the source unit. REMOTE OUT If using additional amplifiers and tower speakers connect the REMOTE OUT terminal using a 1/4" spade connection to the Remote input terminal of the other amplifier. The REMOTE OUT works in conjuction with the Power switch on the microphone (please refer to page 5). [. . . ] Mounting the microphone holder. MICROPHONE OPERATION POWER SWITCH OFF ­ Turns the 6100 system off. AUTO ­ Allows the 6100m system to operate in conjunction with the REMOTE trigger from your head unit. ON ­ Turns the 6100m system ON; allows the PA feature to be used without having to turn the audio system on. ­ Check all input connections from source unit. [. . . ]