User manual INFINITY CASCADE SEVEN

[. . . ] In 6- or 7-channel configurations, place the rear channel(s) behind the listening position, as shown in Figures 2 and 3. NOTE: An Infinity powered subwoofer will add impact and realism to both music and film soundtracks. Contact your Infinity dealer for recommendations on subwoofer models for your application. Infinity Subwoofer (optional) Left Channel Right Channel Left Front Channel Center Channel Right Front Channel Listening Position Couch Figure 1. Experiment with speaker placement to obtain the best bass level and stereo imaging in your room. Left Surround Channel Left Rear Channel Center Rear Channel Right Rear Channel Right Surround Channel Figure 2. This overhead view shows a typical home theater plan. [. . . ] Note: Spiked feet must be fully threaded into holes provided in the base to ensure stability. Locking Nut SEE DETAIL A DETAIL A 5/8" min. Spike End Foot 5/8" Round End Nylon Dome (included for use on wood floors) Model Three V 1. Securely fasten one cleat to the middle set of holes on the rear of the speaker using two included 1/4"-20 panhead screws. Slide speaker with cleat over the base. CARPETED FLOORS HARD-SURFACE FLOORS This cross section shows how to install the spikes onto the bottom of a Cascade Model Nine and Model Seven. + + Model Five 1. Securely fasten one cleat to the set of holes above the terminal using two included 1/4"-20 panhead screws. Slide speaker with cleat over the base. + + 4 CASCADE SPEAKER SYSTEMS WALL-MOUNTING NOTE: The customer is responsible for the correct selection and use of mounting hardware (available through hardware stores) that will ensure the proper and safe wall-mounting of the speakers. Attaching the Grilles The Cascade loudspeakers use a unique frameless grille. Each end of the grille cloth contains a magnet. Simply curl the magnet assembly behind the grille cloth, place one end of the grille just above the tweeter and then gently pull the grille taut, attaching the other end of the grille just below the woofer. Model Three V, Model Three C, Model Five 1. Attach wall bracket to wall at desired location. Model Three C Model Five Model Three V 2. Securely fasten the two cleats to the rear of the speaker, using the outermost holes, using two included 1/4"-20 panhead screws per cleat. + + 3. Carefully slide the cleats on the rear of the speakers over the tabs of the wall bracket. wall CASCADE SPEAKER SYSTEMS 5 WIRING THE SYSTEM IMPORTANT: Make sure all equipment is turned off before making any connections. For speaker connections, use a high-quality speaker wire with polarity coding. The side of the wire with a ridge or other coding is usually considered positive polarity (i. e. , +). NOTE: If desired, consult your local Infinity dealer about speaker wire and connection options. To ensure proper polarity, connect each + terminal on the back of the amplifier or receiver to the respective + (red) terminal on each speaker, as shown in Figure 4. Connect the ­ (black) terminals in a similar way. See the owner's guides that were included with your amplifier or receiver and television to confirm connection procedures. IMPORTANT: Do not reverse polarities (i. e. , + to ­ or ­ to +) when making connections. Doing so will cause poor imaging and diminished bass response. Figure 5. This example shows how to connect bare wires to the terminals. [. . . ] If this happens, try angling the speakers slightly inward toward the listening position until the optimum effect is achieved. CARE OF YOUR SPEAKER SYSTEM Figure 7. Each Cascade Series enclosure has a finish that does not require any routine maintenance. When needed, use a soft cloth to remove any fingerprints or dust from the enclosure. NOTE: Do not use any cleaning products or polishes on the cabinet or grille. Single-Stereo Amplifier If a problem occurs, make sure that all connections are properly made and clean. [. . . ]