User manual INFINITY SAT-750

[. . . ] Since the speakers are magnetically shielded, you can place them without worrying about the field distorting the TV picture. For surround-channel use, place speakers on bookshelves or stands alongside the listening position. Final placement depends on room acoustics, availability of space, and your listening preference (Figures 2 and 3). [. . . ] There is a wall bracket for each satellite speaker. Each speaker bracket will require (2) 1-1/2, " #10 wood screws; each screw should be fastened to a wall stud. If a wall stud is unavailable, install an anchor appropriate for a 1-1/2, " #10 screw. NOTE: The customer is responsible for the correct selection and use of mounting hardware (available through hardware stores) that will ensure the proper and safe wall-mounting of the speakers. Mark the positions on the wall where you would like to place the mounting screws. Place bracket against wall and fasten two 1-1/2, " #10 wood screws through the bracket's screw holes into the wall. If a wall stud is not available, use an appropriate anchor. Place the speaker on the wall by sliding the opening on the bottom of the speaker over the bracket hook on the wall. Once positioned properly, the speaker should slide down slightly and become secure. keyhole on the back of the speaker to the screwhead on the wall. Once positioned properly, the speaker should slide down slightly and become secure. SPEAKER CONNECTIONS Turn Off All Power First, turn off all audio-system power. Use high-quality speaker wire to make your connections. #18-Gauge speaker wire with polarity coding is recommended. For longer distances, #16-gauge or heavier wire is recommended. The side of the wire with a ridge or other coding is usually considered positive polarity (i. e. , +). Also, consult the owner's manuals that were included with your amplifier or receiver to confirm connection procedures. Observe polarities when making speaker connections, as shown in Figure 5. [. . . ] If the problem remains in the same speaker, then the fault is with the loudspeaker. If the problem appears in the opposite speaker, the cause is in another component or cable. In the event that your SAT-750 ever needs service, contact your local Infinity dealer or Infinity directly at 516-674-4INF (USA only) or www. infinitysystems. com for a service center near you. Midrange Driver(s): High-Frequency Driver: Dimensions (H x W x D): Weight: Infinity continually strives to update and improve existing products, as well as create new ones. The specifications and construction details in this and related Infinity publications are therefore subject to change without notice. 4 SAT-750 INFP1419SAT-750 OM 8/11/03 10:38 AM Page 7 NOTES INFP1419SAT-750 OM 8/11/03 10:37 AM Page 8 © 2003 Harman International Industries, Incorporated Infinity Systems, 250 Crossways Park Drive, Woodbury, NY 11797 USA 516. 674. 4INF (USA only) www. infinitysystems. com * Trademarks of Dolby Laboratories. [. . . ]