User manual INFINITY TSS-FMK4000

[. . . ] TSS-4000 TOTAL SPEAKER SOLUTIONS TSS-FMK4000 Owner's Guide INTRODUCTION The TSS-FMK4000 allows you to recess a TSS-SAT4000 or TSS-CENTER4000 into the wall. [. . . ] Keep the shipping carton and packing materials for future use. Contents Please verify that the package contains the following items: (1) 3/16"-Thick Cardboard Template (2) End Brackets (1) Speaker Frame (2) Mounting Blocks (4) #8 x 1" Flat-Head Wood Screws (2) Sealing Strips (4) #8 x 1-1/8" Pan-Head Wood Screws (2) 1/4-20 x 3/4" Flat-Head Machine Screws 2 TSS-FMK4000 Important Notes: 1) In order to horizontally flush-mount the TSS-CENTER4000 in a wall with standard 16" spacing between the studs, some modification to that area of the wall will be necessary. This type of installation will require a professional licensed contractor to install horizontal braces that comply with the customer's local building codes. 2) For a satellite installation, follow all the steps but cut the hole in a vertical direction, perpendicular to the floor. See exploded view on page 7. Step One Remove both end caps of the speaker by unscrewing the single center screws. Speaker End Cap Center Screw 1/4-20 x 3/4" Screw Step Two Attach both of the end brackets to the speaker ends with the 1/4-20 x 3/4" flat-head machine screw, as shown. 1/4-20 x 3/4" Flat-Head Machine Screw End Bracket 1/4-20 x 3/4" Flat-Head Machine Screw End Bracket TSS-FMK4000 3 Step Three After you have found the correct placement on the wall for the speaker, use the template provided to draw the exact-sized hole required. Make sure to use a level when positioning the template to ensure that your installation is level. Then cut out the drywall to create the hole. Wall NOTE: The hole for the speaker should be 22-1/2" x 4-3/8. " Template Screw Holes Step Four Place the mounting blocks inside the hole at either end. Use two #8 x 1" flat-head wood screws to secure them in place. Mounting Block (4) #8 x 1" Flat-Head Wood Screws Mounting Block 4 TSS-FMK4000 Step Five Attach speaker wires as described in the speaker's owner's manual and, using four #8 x 1-1/8" pan-head wood screws provided, screw the speaker assembly into place, making sure that the screws anchor themselves into the mounting blocks behind the drywall. (4) #8 x 1-1/8" Pan-Head Wood Screws Step Six Apply the sealing strips to either side of the speaker to cover the remaining openings of the cutout in the drywall. Sealing Strip TSS-FMK4000 5 Step Seven Remove the paper cover from the gasket on the speaker-facing side of the frame. [. . . ] The specifications and construction details in this and related Infinity publications are therefore subject to change without notice. [. . . ]