User manual INFOCUS IN20

[. . . ] IN20 SERIES Reference Guide Declaration of Conformity Manufacturer: InFocus Corporation, 27700B SW Parkway Ave. Wilsonville, Oregon 97070 USA European Office: Strawinskylaan 585, 1077 XX Amsterdam, The Netherlands We declare under our sole responsibility that this projector conform to the following directives and norms: EMC Directive 89/336/EEC, Amended by 93/68/EEC EMC: EN 55022 EN 55024 EN 61000-3-2 EN 61000-3-3 Low Voltage Directive 73/23/EEC, Amended by 93/68/EEC Safety: IEC 60950-1: 1st Edition March, 2006 FCC Warning Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Select­confirms choices made in the menus (page 27). Up/Down arrows­navigates to and adjusts settings in the menus (page 27). Source­changes the active source. menu navigation buttons 24 Optimizing computer images After your computer is connected properly and the computer's image is on the screen, you can optimize the image using the onscreen menus. For general information on using the menus, see page 27. · · · · · Adjust the Keystone, Contrast, or Brightness in the Picture menu (page 28). Choose the option that best fits your input source (page 28). Adjust the Color Temperature in the Advanced menu (page 30). Adjust the Phase, Tracking, or Horizontal or Vertical position in the Advanced menu (page 29). Once you have optimized the image for a particular source, you can save the settings using Presets. This allows you to quickly recall these settings later (page 29). Presentation features Several features are provided to make giving presentations easier. Here is an overview, details are found in the menu section. · The Custom key, available on several optional remotes only, allows you to assign various features to the button. The default effect is Source Info, which displays information about the projector and current source. The Startup Logo option lets you change the default start up screen to a blank or default screen (page 32). Two options, Power Save and Screen Save, are provided to automatically shut down the projector after several minutes of inactivity or display a black screen. This helps preserve lamp life (page 31). · · 25 Optimizing video images After your video device is connected properly and the image is on the screen, you can optimize the image using the onscreen menus. For general information on using the menus, see page 27. · · · · · · Adjust the Keystone, Contrast, Brightness, Color, or Tint in the Picture menu (page 28). Choose the option that best fits your input source (page 28). Use the Color Control to adjust the color gain (page 30). Turn on Overscan to remove noise on the edges of the image. Customizing the projector You can customize the projector for your specific setup and needs. See page 31 to page 33 for details on these features. [. . . ] Select OK or Cancel by pressing the Select button. To reset the PIN back to the default: Power up the projector. After the "Enter PIN" dialog box appears, press and hold the Select button down for 10 seconds. Enter the default PIN to use the projector. [. . . ]