User manual INFOCUS LP600

[. . . ] Replacing the projection lamp The lamp hour timer in the About menu counts the number of hours the lamp has been in use. Fifty hours before the specified end of the lamp's life, the message "Replace lamp" briefly appears on the screen at each startup and in the Interactive Display. [. . . ] Unplug the power cord before replacing the lamp. Fingerprints can obscure projection sharpness. Be extremely careful when removing the lamp housing. In the unlikely event that the lamp ruptures, small glass fragments may be generated. The lamp module is designed to contain most of these fragments, but use caution when removing it. Before replacing a ruptured lamp, clean the lamp compartment and dispose of cleaning materials. This product has a lamp which contains a very small amount of mercury. Dispose of it as required by local, state or federal ordinances and regulations. For more information see www. eiae. org. Loosen the screw on the lamp module Wait 60 minutes Turn off and unplug the projector 4 : Pry the lamp door off Unplug the lamp connector. 5 6 7 8 9 Detach the lamp connector from the projector by gently pulling the connector until it is disconnected from the projector. Carefully remove the lamp module by grasping and lifting the metal handle. Dispose of the lamp in an environmentally proper manner. Install the new lamp module, making sure that it is properly seated. [. . . ] To reset the lamp timer, press the decrease volume button on the keypad and the increase volume button simultaneously for 10 seconds. You can also navigate to the Settings>Service menu and select Lamp Reset to reset the lamp timer. Reset the lamp timer in the Service menu 009-0935-01 [. . . ]