User manual INFOCUS SCREENPLAY 4805

[. . . ] ScreenPlay 4805 User's Guide [ English · Français · Deutsch · Español · Italiano · Norsk · Nederlands] Declaration of Conformity Manufacturer: InFocus Corporation, 27500 SW Parkway Ave. Wilsonville, Oregon 97070 USA European Office: Strawinskylaan 585, 1077 XX Amsterdam, The Netherlands We declare under our sole responsibility that this projector conform to the following directives and norms: EMC Directive 89/336/EEC, Amended by 93/68/EEC EMC: EN 55022 EN 55024 EN 61000-3-2 EN 61000-3-3 Low Voltage Directive 73/23/EEC, Amended by 93/68/EEC Safety: EN 60950: 2000 March, 2004 FCC Warning Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] If playing a video, make sure the playback has not been paused. adjust volume connect audio cable Connecting external speakers The projector can be attached to external speakers that have their own power source by plugging a speaker cable (not included) into the projector's Audio Out connector. external speakers with own power source audio out speaker cable 29 Using the keypad buttons Most buttons are described in detail in other sections, but here is an overview of their functions: Menu­opens the on-screen menus (page 32). Select­confirms choices made in the menus (page 32). Up/Down arrows­navigates to and adjusts settings in the menus (page 32). Auto Image­resets the projector to the source. Presets­cycles through the available preset settings (page 34). Keystone­adjusts squareness of the image (page 12). Video and Computer­changes the active source. menu navigation buttons 30 Optimizing computer images After your computer is connected properly and the computer's image is on the screen, you can optimize the image using the onscreen menus. For general information on using the menus, see page 32. · · · · · Adjust the Keystone, Contrast, or Brightness in the Picture menu (page 33). Choose the option that best fits your input source (page 33). Adjust the Color Temperature in the Advanced menu (page 35). Adjust the Phase, Tracking, or Horizontal or Vertical position in the Advanced menu (page 37). Once you have optimized the image for a particular source, you can save the settings using Presets. This allows you to quickly recall these settings later (page 34). · · press the Resize button on the remote to cycle through the options. Auto tries to determine the standard of the incoming video. Select a different standard if necessary. Make sure your DVD player is set for a 16:9 television. See your DVD player's user's guide for instructions. · Customizing the projector You can customize the projector for your specific setup and needs. See page 38 to page 40 for details on these features. · · · · · · · · For rear projection, turn rear mode on in the Settings>System menu. For ceiling mounted projection, turn ceiling mode on in the Settings>System menu. [. . . ] Remanufactured Products and Software Products are exempt from the foregoing Limited Warranty. Please refer to the appropriate Remanufactured Product Limited Warranty or Software Product Limited Warranty for applicable Warranty information. DISCLAIMER OF UNSTATED WARRANTIES THE WARRANTY PRINTED ABOVE IS THE ONLY WARRANTY APPLICABLE TO THIS PRODUCT. ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR PARTICULAR PURPOSE ARE DISCLAIMED. [. . . ]