User manual INFOCUS X1A

[. . . ] X1a MULTI-USE PERFORMANCE USER'S GUIDE Declaration of Conformity Manufacturer: InFocus Corporation, 27700B SW Parkway Ave. Wilsonville, Oregon 97070 USA European Office: Strawinskylaan 585, 1077 XX Amsterdam, The Netherlands We declare under our sole responsibility that this projector conform to the following directives and norms: EMC Directive 89/336/EEC, Amended by 93/68/EEC EMC: EN 55022 EN 55024 EN 61000-3-2 EN 61000-3-3 Low Voltage Directive 73/23/EEC, Amended by 93/68/EEC Safety: EN 60950: 2000 April, 2004 FCC Warning Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Previous and Next buttons allow you to navigate through your PowerPoint presentation while in Slide Show mode. Connect the USB connector on the provided computer cable to your computer to use these buttons. When you do this for the first time, the Add New Hardware wizard may appear. See page 15 for details on loading the correct USB drivers. previous button next button navigation buttons Troubleshooting the remote · · Make sure the batteries are installed in the proper orientation and are not dead. Make sure you're pointing the remote at the projector or the screen, not the computer, and are within the remote range of 15 feet (4. 5m). For best results, point the remote at the screen. If you are trying to advance PowerPoint slides, make sure the USB cable is connected. If using a USB cable, make sure the correct drivers are installed. · 30 Using the audio Using the projector's speakers To use the projector's speaker, connect your source to the Audio In connectors (L and/or R) on the projector's composite connectors. To adjust the volume, press the Volume buttons on the keypad. If you purchased the optional remote, you can mute the sound by pressing the remote's Mute button. Troubleshooting Audio If you aren't hearing the audio, check the following: · · · · · Make sure the audio cable is connected. Make sure the volume is turned up enough. If playing a video, make sure the playback has not been paused. adjust volume connect audio cable 31 Using the keypad buttons Most buttons are described in detail in other sections, but here is an overview of their functions: Menu­opens the on-screen menus (page 35). Select­confirms choices made in the menus (page 35). Up/Down arrows­navigates to and adjusts settings in the menus (page 35). Auto Image­resets the projector to the source. Presets­cycles through the available preset settings (page 37). Keystone­adjusts squareness of the image (page 13). Video and Computer­changes the active source. menu navigation buttons 32 Optimizing computer images After your computer is connected properly and the computer's image is on the screen, you can optimize the image using the onscreen menus. For general information on using the menus, see page 35. · · · · · Adjust the Keystone, Contrast, or Brightness in the Picture menu (page 36). Choose the option that best fits your input source (page 36). [. . . ] Product repair outside of the terms of the Limited Warranty will be on a time and materials basis. Prolonged Product "demonstration" causes unusual Product wear and is not considered normal use under the terms of this Limited Warranty. The Accessory Product Limited Warranty covers the accessory item only and excludes normal wear. The Lamp Product Limited Warranty excludes expected lamp degradation. [. . . ]