User manual INFOSEC 1100 XP SOHO

[. . . ] Do not connect any non-computer units to the UPS, such as medical equipment for artificial life handling, microwave, vacuum cleaner, etc. Laser printers should not be connected to the UPS as they consume too much power. Make sure that the power supply required does not exceed the capacity of the UPS. We recommend using an optimum power load equivalent to half or one third of the nominal power for longer backup time and battery life. [. . . ] You will find the technical information you require on your guarantee or on the identification plate on the back of the unit. If convenient you may enter the details in the following box. At the end of their lives, they have to be collected separately. On / Off switch Lighting green led : AC mode Flashing green led : Battery mode Checking When you receive your equipment, open the packaging and check that your UPS has not been damaged. Charging the batteries This unit is shipped from the factory with its internal battery fully charged, however, some charge may be lost during shipping and the battery should be recharged prior to use. Plug the unit into an appropriate power supply and allow the UPS to charge fully by leaving it plugged-in, with no load, for at least 8 hours. Where to set up The UPS has been designed to operate in a protected environment, at temperatures between 0°C and 40°C and at a humidity level ranging between 0% and 90% (no condensation). Install the unit in an environment which is free from dust, chemical vapours and conductors. Moreover, in order to avoid any interference, keep the UPS at least 20cm away from the CPU (central processing unit). Connection Check on the identification plate at the back of the UPS that the power supply is compatible with network voltage and that the device is powerful enough to protect the given power load. Plug the UPS into a 2-pole, earthed outlet (use the original power cable of your computer or it is recommended to use a power cable 2P+E/CEE22/10A). Then, use the 2 IEC cables to connect one computer-related device to each of the power outlets supplied on the back of the UPS. You can also connect a device that does not require backup time, such as a printer, to the surge protected and filtered outlet. On/Off To turn the UPS unit on, lightly press the power switch. To turn it off, press the power switch again. DC Start XP units are equipped with an integrated DC start function. To start the UPS in the absence of a power supply and with a full battery, press the button. Power Saving Function XP range is equipped with a Power Saving Function. [. . . ] UPS backup time will depend on the powered load, as well as the age and condition of the batteries. Batteries have a very high short circuit current: connection errors could cause electric arcs resulting in serious burns. TROUBLE SHOOTING Should the UPS fail to function correctly we recommend you perform the following tests before calling the Hot Line. Is the UPS plugged into the mains power supply? [. . . ]