User manual INFOSEC XP PRO UPS 3000 VA

[. . . ] The UPS is suitable only to computers and electronic equipment with substantially rectifier or capacitive loads. It is not suitable to electronic equipment with significant inductive loads, such as motors & fluorescent lamps. Be sure to operate within the power rating of the UPS. Below 1/2 or 1/3 of rated power is recommended for longer backup time & longer battery life. [. . . ] 3 shows how the UPS works when AC Utility Failure AVR Protection : When AVR is working under regulation mode, the light will turn on. Backup mode: Battery in backup Over Load: If the UPS is overloaded, this light will turn on and the alarm will beep. UPS Cut-Off: Overload or cut-off Battery Level: A bar graph showing how much of the UPS battery is being used. Load Level: A bar graph showing how much of the UPS power is being used. AC line input socket: Connect power cable from the UPS to AC utility. AC input fuse: Contain the fuse to protect the UPS from over current from incoming AC utility. Output receptacles: Connect power cables of computer equipment to these outlets. XP PRO UPS may be installed either in a horizontal or in a vertical position. It is provided with one UPS stand to stabilize the UPS in tower position and two angle flat brackets allow the installation of the UPS as a 19" equipment rack. If there is any obvious damage, immediately report it to the selling dealer or the delivering carrier. If there is no damage to the shipping carton, unpack the unit and inspect the unit for damage. The UPS is designed for installation in a protected environment within a temperature range from 32°F to 104°F and relative humidity of 090% without condensation. Check the identification label to verify the UPS voltage and power rating match the available line voltage and load requirements. Check if the main switch on the UPS front panel is in the off position and insure that the voltage of the AC utility source corresponds to the nameplate on the UPS rear panel. Plug the power cable into the grounded socket. If indicators of LINE-ON & CUT-OFF LCD light on, it means AC power is normal, but UPS is under CUT-OFF status and it will automatically start to charge by itself. Push the main switch, then the Load Level LCD will light on for 2 seconds and CUT-OFF LCD will light off. The UPS is ready to start working normally. Connect your PCs to the UPS and then turn them on. Be sure to check the Load Level LCD indicator and do not overload it over 100%. To simulate AC failure (simply by disconnecting the AC power) may help to insure whether UPS is in good condition or not. When disconnecting the UPS from AC power, the BACKUP LCD lights on and the alarm is sounding every 3 seconds. [. . . ] 5 hours to 90% of full capacity LCD indicator for line on, battery back-up, AVR protection, Overload and cut-off, Load and battery level Sounding every 3 seconds Sounding every 1 second Continue beeping sound Fuse & current limited Fuse & current limited & cut-off No battery drain after cut-off Environment Noise Level Interface Contact Closure Less than 40db (at 1 meter) DB9 connector for connecting with Rups-2000 software If the UPS failed to operate properly, please review the following checks firstly. Is the UPS plugged into a correctly working outlet?Is the line voltage within the rating specified?Please provide the following information when call for service to +33 2 40 76 15 82. [. . . ]