User manual INTEL DUAL-CORE SPECIFICATION UPDATE REV 010

[. . . ] Intel® Pentium® Dual-Core Processor Specification Update December 2010 Revision 010 INFORMATION IN THIS DOCUMENT IS PROVIDED IN CONNECTION WITH INTEL® PRODUCTS. NO LICENSE, EXPRESS OR IMPLIED, BY ESTOPPEL OR OTHERWISE, TO ANY INTELLECTUAL PROPERTY RIGHTS IS GRANTED BY THIS DOCUMENT. EXCEPT AS PROVIDED IN INTEL'S TERMS AND CONDITIONS OF SALE FOR SUCH PRODUCTS, INTEL ASSUMES NO LIABILITY WHATSOEVER, AND INTEL DISCLAIMS ANY EXPRESS OR IMPLIED WARRANTY, RELATING TO SALE AND/OR USE OF INTEL PRODUCTS INCLUDING LIABILITY OR WARRANTIES RELATING TO FITNESS FOR A PARTICULAR PURPOSE, MERCHANTABILITY, OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT. UNLESS OTHERWISE AGREED IN WRITING BY INTEL, THE INTEL PRODUCTS ARE NOT DESIGNED NOR INTENDED FOR ANY APPLICATION IN WHICH THE FAILURE OF THE INTEL PRODUCT COULD CREATE A SITUATION WHERE PERSONAL INJURY OR DEATH MAY OCCUR. [. . . ] This operation will set the Null bit in the segment selector if a Null result is generated, but it does not generate a #GP on the SYSENTER instruction itself. An exception will be generated as expected when the SS register is used to access memory, however. The SYSEXIT instruction will also exhibit this behavior for both CS and SS when executed with the value in SYSENTER_CS_MSR between FFF0h and FFF3h, or between FFE8h and FFEBh, inclusive. Implication: These instructions are intended for operating system use. If this erratum occurs (and the OS does not ensure that the processor never has a Null segment selector in the SS or CS segment registers), the processor's behavior may become unpredictable, possibly resulting in system failure. Workaround: Do not initialize the SYSTEM_CS_MSR with the values between FFF8h and FFFBh, FFF0h and FFF3h, or FFE8h and FFEBh before executing SYSENTER or SYSEXIT. Status: For the steppings affected, see the Summary Tables of Changes. AN47. Problem: Writing the Local Vector Table (LVT) When an Interrupt Is Pending May Cause an Unexpected Interrupt If a local interrupt is pending when the LVT entry is written, an interrupt may be taken on the new interrupt vector even if the mask bit is set. Implication: An interrupt may immediately be generated with the new vector when a LVT entry is written, even if the new LVT entry has the mask bit set. If there is no Interrupt Service Routine (ISR) set up for that vector the system will GP fault. If the ISR does not do an End of Interrupt (EOI) the bit for the vector will be left set in the in-service register and mask all interrupts at the same or lower priority. Workaround: Any vector programmed into an LVT entry must have an ISR associated with it, even if that vector was programmed as masked. This ISR routine must do an EOI to clear any unexpected interrupts that may occur. The ISR associated with the spurious vector does not generate an EOI, therefore the spurious vector should not be used when writing the LVT. Status: For the steppings affected, see the Summary Tables of Changes. 32 Specification Update Errata AN48. Problem: Using 2M/4M Pages When A20M# Is Asserted May Result in Incorrect Address Translations An external A20M# pin if enabled forces address bit 20 to be masked (forced to zero) to emulates real-address mode address wraparound at 1 megabyte. However, if all of the following conditions are met, address bit 20 may not be masked. · paging is enabled · a linear address has bit 20 set · the address references a large page · A20M# is enabled Implication: When A20M# is enabled and an address references a large page the resulting translated physical address may be incorrect. This erratum has not been observed with any commercially available operating system. Workaround: Operating systems should not allow A20M# to be enabled if the masking of address bit 20 could be applied to an address that references a large page. A20M# is normally only used with the first megabyte of memory. Status: For the steppings affected, see the Summary Tables of Changes. AN49. Counter Enable bit [22] of IA32_CR_PerfEvtSel0 and IA32_CR_PerfEvtSel1 Do Not Comply with PerfMon (Architectural Performance Monitoring) Specification According to the Architectural Performance Monitoring specification the two PerfMon counters can be disabled/enabled through the corresponding Counter Enable bit [22] of IA32_CR_PerfEvtSel0/1. Due to this erratum the following occurs: 1. bit [22] of IA32_CR_PerfEvtSel0 enables/disables both counters bit [22] of IA32_CR_PerfEvtSel1 doesn't function Problem: Implication: Software cannot enable/disable only one of the two PerfMon counters through the corresponding Counter Enable bit [22] of IA32_CR_PerfEvtSel0/1. Workaround: Software should enable/disable both PerfMon counters together through Counter Enable bit [22] of IA32_CR_PerfEvtSel0 only. Alternatively, Software can effectively disable any one of the counters by clearing both Kernel and App bits [17:16] in the corresponding IA32_CR_PerfEvtSel0/1. [. . . ] Workaround: Although it is possible to have a single physical page mapped by two different linear addresses with different memory types, Intel has strongly discouraged this practice as it may lead to undefined results. Software that needs to implement memory aliasing should manage the memory type consistency Status: For the steppings affected, see the Summary Tables of Changes. AN108. Problem: A WB Store Following a REP STOS/MOVS or FXSAVE May Lead to Memory-Ordering Violations Under certain conditions, as described in the Software Developers Manual section "Out-of-Order Stores For String Operations in Pentium 4, Intel Xeon, and P6 Family Processors", the processor may perform REP MOVS or REP STOS as write combining stores (referred to as "fast strings") for optimal performance. FXSAVE may also be internally implemented using write combining stores. Due to this erratum, stores of a WB (write back) memory type to a cache line previously written by a preceding fast string/FXSAVE instruction may be observed before string/FXSAVE stores. Implication: A write-back store may be observed before a previous string or FXSAVE related store. [. . . ]