User manual INTELLINET 520638

[. . . ] Wireless Broadband (Switch) Router Standard/Pro/Advanced/Advanced+ User's Guide Version: 2. 10 Last Updated: 01/17/2003 Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiated radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] In addition, changes are highlighted in red. Clicking Cancel discards all the changes. Clicking Restart restarts the WIASA for the settings changes to take 20 effect. Fig. At the bottom of each status page that shows read-only information, there are two buttons--Home and Refresh. Clicking Home brings you back to the start page. Clicking Refresh updates the shown status information. 3. 2. On this page, the status information of each associated client, including its MAC address, IP address, user name (if the client has been IEEE 802. 1x authenticated), number of bytes it has send, number of 21 bytes it has received, and the time of its last activity, is shown. 3. 2. 2. On this page, all the current static or dynamic DHCP mappings are shown. A DHCP mapping is a correspondence relationship between an IP address assigned by the DHCP server and a computer or device that obtains the IP address. A computer or device that acts as a DHCP client is identified by its MAC address. A static mapping indicates that the DHCP client always obtains the specified IP address from the DHCP server. You can set static DHCP mappings in the Static DHCP Mappings section of the DHCP Server configuration page (see Section 3. 4. 4). A dynamic mapping indicates that the DHCP server chooses an IP address from the IP address pool specified by the First allocateable IP address and Allocateable IP address count settings on the DHCP Server configuration page. 3. 2. 3. System events such as PPPoE dialup results are recorded in the memory of the WIASA. The logged information is useful for troubleshooting purposes. 22 3. 3. On this page, you can specify the operational mode for the WIASA. Currently, 5 modes are available: Simple Access Point. In this mode, the Ethernet WAN interface is disabled. The WIASA acts as a bridge between the Ethernet LAN interface and the IEEE 802. 11b wireless LAN interface. Router with a PPPoE-based DSL/Cable Connection. In this mode, the WIASA assumes that a DSL or cable modem is connected to its Ethernet WAN interface. The client computers can therefore share this DSL/cable-based Internet connection by the NAT server functionality. [. . . ] Make sure the IP address of the client computer and the IP address of the WIASA are in the same IP subnet. TIP: If you forget the current IP address of the WIASA, use Wireless Router/AP Browser to get the information (see Appendix B-3). The default gateway of the WIASA does not respond to ping from the client computer. You may find out the answer by directly connecting the modem to a computer. [. . . ]