User manual INTELLINET 521802 INSTRUCTION MANUAL

[. . . ] Trademarks NetWare is a registered trademark of Novell Inc and Windows 95/98/Me and Windows NT/2000/XP are registered trademarks of Microsoft Corp. All other brands and product names are trademarks of their respective companies. Copyright No part of this publication may be reproduced in any form or by any means or used to make any derivative (such as translation, transformation or adaptation) without the express written consent of the manufacturer as stipulated by the United States Copyright Act of 1976. FCC Warning This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to subpart J of Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. [. . . ] You may also use the Generic PPD if you do not need any printer specific features. Network Print Monitor Preparation The print server supports TCP/IP, IPX/SPX and NetBEUI protocols under Windows 95/98/Me/NT/2000/XP. Please make sure that the following steps have been completed before proceeding with installation under Windows PC. Select A Desired Protocol TCP/IP The TCP/IP Protocol must be installed. For further information, please read "TCP/IP Protocol Installation" section in this chapter. Note: If TCP/IP protocol is chosen, please refer to "Assigning an IP Address to the print server" section later in this chapter. 6-1 Network Print Monitor IPX/SPX The IPX/SPX-compatible Protocol must be installed. For further information, please read "IPX/SPX-compatible Protocol Installation" section in this chapter. NetBEUI The NetBEUI protocol must be installed. For further information, please read "NetBEUI Protocol Installation" section in this chapter. 6-2 Network Print Monitor TCP/IP Protocol Installation 1. Click Start, point to Settings and select Control Panel. If the TCP/IP Protocol is not already installed, click Add. Select Microsoft from the Manufacturers list. Select TCP/IP Protocol from the Network Protocols list. Specify an IP address, Subnet Mask, and Gateway address or specific "Obtain IP address automatically", if a DHCP server is available on the LAN. 9. Note: Using TCP/IP protocol to access the print server requires well-configured TCP/IP settings. If you are not familiar with these settings, please consult your network administrator for details or ask for help. 6-3 Network Print Monitor IPX/SPX-compatible Protocol Installation 1. Click Start, point to Settings, and select Control Panel. If the IPX/SPX-compatible Protocol is not already installed, click Add. Select Microsoft from the Manufacturers list. Select IPX/SPX-compatible Protocol from the Network Protocols list and follow the instructions on the screen. 8. 6-4 Network Print Monitor NetBEUI Protocol Installation 1. Click Start, point to Settings, and select Control Panel. If the NetBEUI is not already installed, click Add. Select Microsoft from the Manufacturers list. Select NetBEUI from the Network Protocols box and follow the instructions on the screen. [. . . ] The Print server Name/Print Queue configuration in PCONSOLE is incorrect. The Print server name specified and stored in the print server memory doesn't match the same one set in PCONSOLE. The network cable or power adapter connected to the print server is loose or disconnected. The printer is off-line, jammed or out of paper. Solutions 1. [. . . ]