User manual INTERMATIC 158ET11893

[. . . ] BATTERY POWERED CLOCK OPERATION: 2 Years minimum (Two AAA industrial grade alkaline supplied with time switch) MIN. "ON" or "OFF" TIME: 1 minute. "ON" or "OFF" TIME: 6 days 23 hours 59 minutes. (1. 1 Kg) CASE: NEMA 1 drawn steel; 7-3/4" (19. 7 cm) high, 5" (12. 7 cm) wide, 3" (7. 6 cm) deep; gray finish w/lockable spring hasp. [. . . ] Strip the supply and load wires by removing 1/2 inch of insulation. Insert the wire ends under the proper terminal plates and tighten the screws firmly. Connect ground wire to grounding terminal at bottom of case. Be sure that the batteries are functioning properly. This can be checked by making sure the display is visible. If the display has scrambled information, press the [RESET] switch. Note that the batteries can easily be replaced without removing the time switch mechanism or field wiring. Simply press in and downward (in the direction of the arrows) on the battery cover. It is recommended that the batteries be replaced with two "AAA" industrial grade alkaline cells at two to three year intervals as part of the normal time switch maintenance observing battery polarity markings when installing. While pressing and holding the [ENTER] button press the [RESET] button. The display will now be flashing 12:00 A. M. The time switch is now ready for programming. FIgure 3 Programming Steps By pressing the [MODE] button the time switch will cycle through the menus necessary for programming the current date, time, astro zone, astro events, and timed events. Note: The Date and Time must be entered before any other menus will become available for programming. MANUAL MODE Press the [MODE] button repeatedly until MANUAL appears in the upper portion of the display. While in this mode the time switch does not follow any programmed settings, but can be forced on using the [ON/OFF] load button(s). DATE set Press the [MODE] button repeatedly until SET DATE appears in the upper portion of the display. Enter the current date using the [ ], [ ], and [ENTER] keys. TIME set Press the [MODE] button repeatedly until SET CLOCK appears in the upper portion of the display. Enter the current time using the [ ] and [ ] keys. Press [MODE] to advance. ASTRO ZONE set Press the [MODE] button repeatedly until SET ASTRO ZONE appears in the upper portion of the display. Select the proper astro zone using [ ] and [ ] keys (See Figure #5). Press [Mode] to advance. Note: For multi-circuit clocks there are multiple Sunup and Sunset times allowing the user to use different offsets for the different loads if desired. SUNUP set Press the [MODE] button repeatedly until SET SUNUP appears in the upper portion of the display. Set the sunup time(s) using [ ] and [ ] keys, the morning sunrise is automatically calculated by the timer. [. . . ] The warranty does not apply to: (a) damage caused by accident, abuse, mishandling, dropping, acts of God, or any negligent use; (b) units which have been subject to unauthorized repair, opened, taken apart, or otherwise modified; (c) units not used in accordance with directions; (d) damages exceeding the cost of the product. Some states do not allow a limitation of damages, so the foregoing limitation may not apply to you. This warranty gives you specific legal rights and you may have other rights that vary from state to state. INTERMATIC INCORPORATED WILL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. [. . . ]