User manual INTERMATIC 158HA11643REF

[. . . ] Thank you for purchasing Intermatic's HomeSettings devices. With the HomeSettings program you can reliably and remotely control lighting and appliances. SCREW-IN LAMP MODULE MODEL HA05 For use in dry, damp or wet locations. The outstanding features of the HomeSettings HA05 Screw-in Lamp Module includes: · Feedback that will allow you to see whether your device has received the ON/OFF (you cannot DIM with this module) signal. [. . . ] To manually turn OFF the HA05 Screw-in Lamp Module, simply press and release the Program/ON/OFF button. The green indicator will turn OFF and the lightbulb screwed into the HA05 Screw-in Lamp Module will also turn OFF. INSTALLATION If the lightbulb does not turn ON, check to make sure that the lightbulb is seated properly, and check to make sure that your lightbulb is not broken or defective. Intermatic Inc. , Spring Grove, IL 60081- 9698 www. intermatic. com See the instructions for HA07 Master Remote Control or HA09 Handy Remote Control This device complies with part 15 of the FCC rules. Operation of this device is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. PROGRAMMING FEDERAL COMMUNICATIONS COMMISSION STATEMENT NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna or device. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. WARNING!Changes or modifications not expressly approved by Intermatic Inc. could void the user's authority to operate the equipment. Operating Temperature Range: -35°C to 60°C RF range: 50 feet minimum Made In China For use in dry, damp or wet locations. Ratings: 300-Watts Tungsten 42-Watts Compact Fluorescent 120 VAC, 60 Hz TECHNICAL INFORMATION Not recommended for enclosed fixtures with base-above-bulb mounting as shown. Enclosed fixtures with base-below-bulb mounting up to 60-Watts. LIMITED 6-YEAR WARRANTY If within six (6) years from the date of purchase, this product fails due to a defect in material or workmanship, Intermatic Incorporated will repair or replace it, as its sole option, free of charge. [. . . ] This warranty service is available by either (a) returning the product to the dealer from whom the unit was purchased, or (b) mailing the product, along with proof of purchase, postage prepaid to the authorized service center listed below. This warranty is made by: Intermatic Incorporated/After Sales Service/7777 Winn Rd. , Spring Grove, Illinois 60081-9698/815-675-7000 http://www. intermatic. com Please be sure to wrap the product securely to avoid shipping damages. WARRANTY INFORMATION Intermatic Inc. , Spring Grove, IL 60081-9698 158HA11643 [. . . ]