User manual INTERMATIC 158HA11644-ART

[. . . ] · RF signal reliability ­ each HomeSettings product has a special feature that virtually guarantees that RF signals are received · Ease of installation · Manual override · Replaces standard indoor wall switches · Use with décor style wall plate (not included) · 2-way switching only · Compatible with other Z-waveTM enabled devices The HA06 In-Wall Dimmer is a Z-waveTM enabled device and is fully compatible with any Home Settings network and any Z-waveTM enabled network. Z-waveTM enabled devices displaying the ZwaveTM logo can also be used with Home Settings modules and controllers regardless of the manufacturer, and Home Settings modules and controllers can also be used in other manufacturer's Z-waveTM enabled networks. Each module in a Home Settings network is designed to act as a repeater. [. . . ] To manually turn ON the HA06 In-Wall Dimmer, press and release the top half of the wall switch paddle. The green indicator LED will turn ON, and the attached light fixture will also turn ON. To manually turn OFF the HA06 In-Wall Dimmer, simply press and release the bottom half of the wall switch paddle. The green indicator will turn OFF and the attached light fixture will also turn OFF. 9. To manually dim the HA06 In-Wall Dimmer, press and hold the Program/ON/OFF/DIM button until the desired lighting level has been reached. Intermatic, Inc. Spring Grove, IL 60061 www. intermatic. com 158HA11644 INSTALLATION__________________________ Figure 1- Rear View Wiring Diagram Figure 2 - Front View If the attached light fixture does not turn ON, slide the Air-Gap Switch (see Figure 2 above) to the right, into the OFF position (circle "O" shown next to the Air-Gap Switch), and check to make sure that the lamp bulb is not blown out. Check that all wiring connections are correct and that all wiring connectors are properly installed. PROGRAMMING See the instructions for HA07 Master Remote Control or HA09 Handy Remote Control. _ FEDERAL COMMUNICATIONS COMMISSION STATEMENT_____________ This device complies with part 15 of the FCC rules. Operation of this device is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna or device. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] ALL IMPLIED WARRANTIES, INCLUDING THE WARRANTY OF MERCHANTABILITY AND THE WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, ARE HEREBY MODIFIED TO EXIST ONLY AS CONTAINED IN THIE LIMITED WARRANTY, AND SHALL BE OF THE SAME DURATION AS THE WARRANTY PERIOD STATED ABOVE. SOME STATES DO NOT ALLOW LIMITATIONS ON THE DURATIONS OF AN IMPLIED WARRANTY, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU. This warranty service is available by either (a) returning the product to the dealer from whom the unit was purchased, or (b) mailing the product, along with proof of purchase, postage prepaid to the authorized service center listed below. [. . . ]