User manual INTERMATIC 158PE11220

[. . . ] Contact pump manufacturer if not sure and/or for more details. 1 IMPORTANT SAFETY INSTRUCTIONS When installing and operating this Product and other associated equipment, basic safety precautions should always be followed, including the following: 1. This Control must be installed by a qualified electrician, according to National and Local Electrical Codes. Install this control not less than 5 feet (3 meters in Canada) from inside edge of pool. Do not exceed the maximum ratings of individual components, wiring devices, and current carrying capacity of conductors. [. . . ] Testing of the installation is optional and recommended only if the desired loads are securely in place and will not be damaged by this test: a. Digital Time Clock display should fully illuminate and then start to blink 12:00 a. m. Time clock will not blink only if time has been maintained by internal battery. Push each of the ON/OFF buttons to verify devices cycle on and off. In case of unsatisfactory results, turn OFF power, check your wiring, refer to Troubleshooting on Page 3. Install front panel over wiring compartment. The control is now ready for programming, see OPERATION section on Page 4. Figure 1 2 ACCESSORIES FLTR HTR SPA JETS AIR CLNR LITE 1 LITE 2 HIGH LOW AUX 1 AUX 2 AUX 3 W/FA PUMP 1 PUMP 2 External Wired Remote Accessory Part Number 133PE1484A The New Intermatic Wired Remote Control allows you to control your Digital Time Clock from a remote location. Included with your Wired Remote Control is a label arrangement allowing you to identify each button specific to your Pool or spa equipment pad. Your new wired remote control comes standard with 100 foot of cable and is designed to slip fit into any standard 1 1/2" conduit adapter. This remote works in conjunction with the Digital Time Clock and displays feedback information on the present state of the pool or spa equipment pad. For more information refer to instructions provided with the accessory. Freeze Probe Accessory Part Number 178PA28A The New Intermatic Freeze Probe allows you to protect your pool or spa equipment during an unexpected freeze condition. The freeze probe comes with a 10 foot cable and plugs into the back of the new Digital Time Clock. The Time Clock can be programmed to turn on each or all-individual loads at any desired outside temperature. Heater Protection (Fireman) Switch is standard with each Digital Time Clock. It comes standard with a Fireman Switch connection for your pool or spa heater. Simply connect the two wires from your heater thermostat to the back of the digital clock. The fireman switch is only associated with circuit one on the digital clock, therefore the filter pump should be connected to circuit one. Program the time desired for the cool down period and your new digital clock will take over. For more details, refer to instruction manual. TROUBLESHOOTING SYMPTOM 1. Display will not come "ON" when unit is powered up? CAUSE(S) 1a. Jumper on back of clock is missing or set incorrectly. Power to clock not present. CORRECTIVE ACTION Set Jumper to proper location. [. . . ] This warranty is extended to the original house hold purchaser only and is not transferable. this warranty does not apply to: (a) damage to units caused by accident, dropping or abuse in handling, acts of God or any negligent use; (b) units which have been subject to unauthorized repair, opened, taken apart or otherwise modified; (c) units not used in accordance with instructions; (d) damages exceeding the cost of the product; (e) sealed lamps and/or lamp bulbs, LED's and batteries; (f) the finish on any portion of the product, such as surface and/or weathering, as this is considered normal wear and tear; (g) transit damage, initial installation costs, removal costs, or reinstallation costs. INTERMATIC INCORPORATED WILL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU. [. . . ]