User manual INTERMATIC 158WF12660REF

[. . . ] The flow is indicated by a max and min sign. To increase flow, move switch in the direction of max. To decrease flow, move the switch toward min. GENERAL INSTRUCTIONS FOR WATERFALL USE WF401 CAUTION: This pump has been evaluated for use with water only. NOTE: It is recommended the pump be set at its highest flow during assembly and later adjusted to a lower setting if desired. [. . . ] Connect the cable for light to that AC adapter and tighten. INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS IMPORTANT SAFETY INSTRUCTIONS LIGHTED LAMP IS HOT!WARNING: TO REDUCE THE RISK OF FIRE OR INJURY TO PERSONS: · Turn off/unplug and allow to cool before replacing lamp. Contact only switch/plug when turning on. · Keep lamp away from materials that may burn. · Do not touch the lamp at any time. · Do not operate the luminaire fitting with a missing or damaged shield. · Do not touch hot lens. 10W 4 NOTE: Do not let pump run when NOT submerged in water. Always submerge the pump in water first, and then plug in the unit. Fill base with distilled water to approximately 1/2" above pump. Tapwater will create mineral deposits that will result in the corruption of the Waterfall and pump. NOTICE: Do not place outdoors in weather conditions below 32°F, may cause water to freeze. Turn pump on to verify flow making sure it is not too high and everything is operating correctly. Arrange river rocks on top of plate. WARNING: This is not a toy. NOTE: Ensure that the electrical cord loop below the electrical outlet. " This will prevent water from running down the cord into the electrical outlet. 1. Ensure water pump is kept clean and free of debris. We recommend using distilled water with this product. MAINTAINING CLEANLINESS AND LIFE OF WATERFALL & PUMP Motorhead Impeller 2. Periodically change water and clean the structure of the waterfall with a mixture of vinegar and cold clean water. Add water to waterfall periodically to keep water level at an optimum level (approximately 1/2" above pump) to avoid shortening the life of the pump. Water level should completely cover pump at all times. NOTE: To clean pump, first make sure pump is UNPLUGGED from 120V circuit and remove front plate. [. . . ] SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU. THIS WARRANTY IS IN LIEU OF ALL OTHER EXPRESS OR IMPLIED WARRANTIES. ALL IMPLIED WARRANTIES, INCLUDING THE WARRANTY OF MERCHANTABILITY AND THE WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, ARE HEREBY MODIFIED TO EXIST ONLY AS CONTAINED IN THIS LIMITED WARRANTY, AND SHALL BE OF THE SAME DURATION AS THE WARRANTY PERIOD STATED ABOVE. SOME STATES DO NOT ALLOW LIMITATIONS ON THE DURATION OF AN IMPLIED WARRANTY, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU. [. . . ]