User manual INTERMATIC DD150HPS

[. . . ] A mounting suitable for outdoor use and rated for wet locations is required. Follow all applicable electrical codes and regulations. WARNING: Electric shock hazard WARNING: Fire hazard Disconnect power at circuit breaker or fuse box before installing or servicing light. CONNECT TO SUPPLY IN EXTERNAL JUNCTION BOX ONLY. [. . . ] Put the assembly aside and prepare the marked locations for attaching the mounting bracket and arm assembly. Photocontrol Receptacle/socket Photocontrol Fixture Bulb Socket Reflector Extension arm Mounting Bracket Connection Plug (Not Provided) Conduit Connector (Not Provided) Lag Bolts (4) Clamp 3. Mount the extension arm assembly using the hex head lag bolts provided or other suitable method. Secure the mounting bracket solidly to the mounting surface. Lens Conduit (Not Provided) Mounting screws for reflector Figure 1 4. Feed supply wires through the arm and connect them to the fixture using approved twist on wire connectors. Connect the Black fixture wire to the Black (hot) supply wire. Connect the White fixture wire to the White (neutral) supply wire. Connect the supply grounding wire to the green screw located on the one-piece fixture mounting arm clamping bracket. 120 V (BLACK) PHOTO CONTROL WHITE COM X3 RED X1 IGN-01 LAMP X2 Figure 2 COM Secure the fixture to the arm using the one-piece clamping bracket and bolts provided. Fasten the reflector and lens assembly to the fixture using the two screws and washers provided. Screw lamp into socket in lamp holder until finger tight. Insert the photocontrol into the socket on top of the fixture by aligning the prongs and twist clockwise to lock. The arrow on top of control should be pointed away from the mounting surface. If it is not, remove the photocontrol and reposition the socket on the top of the fixture by loosening the screw in the center of the socket. Rotate socket to new position and retighten screw. Turn on the electric power to the fixture. When power if first applied, some controls will turn the light on and turn off in two or three minutes. The fixture will take approximately 5-7 minutes to achieve full illumination. To check operation during daylight, cover the photocontrol with black electrical tape. Allow 3-5 minutes for the fixture to turn off or on when testing. Be sure to remove the tape when testing is completed. 5. [. . . ] ALL IMPLIED WARRANTIES, INCLUDING THE WARRANTY OF MERCHANTABILITY AND THE WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, ARE HEREBY MODIFIED TO EXIST ONLY AS CONTAINED IN THIS LIMITED WARRANTY, AND SHALL BE OF THE SAME DURATION AS THE WARRANTY PERIOD STATED ABOVE. SOME STATES DO NOT ALLOW LIMITATIONS ON THE DURATION OF AN IMPLIED WARRANTY, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU. This warranty service is available by either (a) returning the product to the dealer from whom the unit was purchased, or (b) mailing the product, along with proof of purchase, postage prepaid to the authorized service center listed below. [. . . ]