User manual INTERMATIC DT17

[. . . ] 6 Day button - use during time set to set the day of the week. Use during programming to set individual days, weekdays, weekends or the entire week. 7 HOUR button - use during time set or programming to set the hour. 8 MIN button - use during time set or programming to set the minute. [. . . ] The blinking colon stays on (stops blinking). Push and release DAY to change the day of week. Push and release HOUR to change the hour and AM/PM. Push and release MIN to change the minute. Notes: If you push and hold DAY, HOUR or MIN the display changes quickly. Seconds are set at 0 when the TIME SET button is released if either the HOUR or MIN have been set. Timer Modes MODE Push and release MODE to change the mode. The modes are Countdown timer, Off, Auto, On, and Rand. RESET TIME SET ON/OFF DAY HOUR MIN DS PROG MODE On Mode In the On mode the plugged in light(s) are on. Push PROG ON/OFF to turn the plugged in light(s) off and switch the mode to Off. Rand Mode In Random mode the DT17 randomly switches the connected light(s) on and off. A random on period is + 15 minutes from the programmed times. TH AM On MODE TH AM Rand Countdown timer mode bc In countdown timer mode the clock symbol is displayed (a). When countdown timer mode is a entered the countdown time is set to 75 minutes (b). And the plugged in light(s) are turned on (c). The countdown timer can be set to turn the plugged in light(s) on or off after 75, 60, 45, 30 or 15 minutes. That lets you, for example, set the timer to turn the plugged in light(s) off an hour after you have left the room. The flashing alarm clock symbol indicates the DT17 is in countdown timer mode. To set the countdown timer: Push and release MODE until the countdown timer clock is displayed. (75 minutes is selected. ) If desired, push and release MIN to switch change the countdown to 60, 45, 30, 15 or 0 minutes. If desired, push and release PROG ON/OFF to switch the initial state of the plugged in light(s). Wait ten seconds or push and release TIME SET to start the countdown. While counting down the countdown d timer clock symbol flashes, and you can push TIME SET to switch between the countdown the current time. When the countdown reaches 00:00 the connected light(s) are switched and the clock display remains 00:00 (d). Off Mode In the Off mode the plugged in light(s) are off. You can push PROG ON/OFF to switch to ON mode and turn the plugged in light(s) on. TH How to program the timer: You can program the timer in Auto, ON or Off modes. [. . . ] This warranty is extended to the original household purchaser only and is not transferable. This warranty does not apply to: (a) damage to units caused by accident, dropping or abuse in handling, acts of God or any negligent use; (b) units which have been subject to unauthorized repair, opened, taken apart or otherwise modified; (c) units not used in accordance with instructions; (d) damages exceeding the cost of the product; (e) sealed lamps and/or lamp bulbs, LED's and batteries; (f) the finish on any portion of the product, such as surface and/or weathering, as this is considered normal wear and tear; (g) transit damage, initial installation costs, removal costs, or reinstallation costs. INTERMATIC INCORPORATED WILL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU. [. . . ]