User manual INTERMATIC ET104C

[. . . ] SWITCH RATING: (Per Pole for ET104C) · 30 Amps Inductive/Resistive, 24/120/240 V. A. C. , 60 Hz. · 20 Amps Resistive - 28 V. D. C. , · 1 H. P. · 5 Amps Tungsten, 120/240 V. A. C. , 60 Hz. · 20 Amps Ballast 277 V. A. C. , 60 Hz. [. . . ] Lift the left side of the insulator off of the retaining post and pivot it up and away to expose the terminal strip. Strip the supply and load wires by removing 1/2 inch of insulation. Insert the wire ends under the proper terminal plates and tighten the screws firmly. Connect ground wire to grounding terminal at bottom of case. Be sure that the battery is functioning properly. This can be checked by making sure the display is visible. If the display has scrambled information, press the RESET switch and hold for three to five seconds. Note that the battery can easily be replaced without removing the time switch mechanism or field wiring. simply press in and downward (in the direction of the arrow) on the battery cover which is identified with the word "Battery". It is recommended that the battery be replaced with a "AA" industrial grade alkaline cell at two to three year intervals as part of the normal time switch maintenance observing battery polarity markings when installing. Place the selector switches in the "MANUAL" and "RUN" positions. Press the reset switch for three to five seconds. Refer to the chart below and enter the scheduled events (set points) required. EVENT On 1 Off 2 On 3 Off 4 On 5 Off 6 On 7 Off 8 TIME Install Jumper Only If Timer Input and Load Voltage Are The Same, Otherwise provide a separate source of load power to terminal 3. Programming Steps Refer to programming instructions on time switch door label and note the following: · The MANUAL/AUTO selector can be used to temporarily override the program. Under normal operation the selector should be in the AUTO mode. The MANUAL mode maintains the program but prevents the loads from automatically switching. · The other selector switch is used to set the time of day (TIME SET), the program information (PROGRAM) or to run the program (RUN). FOR A PROGRAM TO FUNCTION PROPERLY, THE TWO SELECTOR SWITCHES MUST BE IN THE AUTO AND RUN POSITIONS. · The RESET switch is used only prior to initially programming the time switch or to erase all programmed set points. · By holding the hour and/or minute buttons depressed you can achieve a fast roll of the displayed time. This is useful when setting the time of day or setting the programmed set points (events). · Up to 4 ON and 4 OFF set points (8 events) can be programmed. [. . . ] This warranty gives you specific legal rights and you may have other rights that vary from state to state. INTERMATIC INCORPORATED WILL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU. THIS WARRANTY IS IN LIEU OF ALL OTHER EXPRESS OR IMPLIED WARRANTIES. [. . . ]