Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual INTERMATIC FL150HPS. We hope that this INTERMATIC FL150HPS user guide will be useful to you.
Lastmanuals help download the user guide INTERMATIC FL150HPS.
Detailed instructions for use are in the User's Guide.
[. . . ] Follow all applicable electrical codes and regulations.
Read instruction sheet carefully before installing fixture. Retain instructions for future reference.
WARNING: Electric shock hazard Disconnect power at circuit breaker or fuse box before installing or servicing light. WARNING: Fire hazard
USE MIN 60ºC SUPPLY CONDUCTORS. [. . . ] Confirm unused voltage fixture wires are appropriately capped within fixture body. Feed the matching voltage fixture wire through the mounting arm. Replace and secure reflector in the same orientation as shown in Figure 2. Close and secure lens door to prevent damage while wiring fixture to mounting. Connect the fixture wire matching the incoming voltage to the black (hot) supply wire. Connect the fixture wire marked COM to the white (neutral) supply wire. Connect the bare copper (fixture ground) wire to the supply grounding wire.
240 V 277 V X3 IGN-01 X1 LAMP
CAP
208 V 120 V COM
3.
4. 6.
Figure 3 Make sure that all wires and connections are inside the mounting wiring compartment and that the cover is properly sealed to keep moisture out. Screw lamp into socket in lampholder until finger-tight. Close lens door, making sure that gasket is in place and compressed to seal out moisture. To weatherproof fixture, seal all holes in housing (mounting conduit, plugs, photocontrols, etc. ) with silicone sealant. To operate, restore power to the circuit and switch light on.
COM
X3
AIMING FIXTURE
WARNING: Electric shock hazard.
1. Turn off power at circuit breaker or fuse box. Rotate mounting arm until light is pointing in the desired direction. Loosen mounting arm bolt (do not remove) and tip fixture to desired angle. If adjustment is needed, turn power OFF at circuit breaker or fuse box and allow fixture to cool before adjusting
Do not turn mounting arm more than 360° after wires are connected. Excessive twisting of wires may loosen connections.
LAMP REPLACEMENT CAUTION: Use lamp of correct type and wattage as specified on fixture.
1. Turn off power at circuit breaker or fuse box. [. . . ] ALL IMPLIED WARRANTIES, INCLUDING THE WARRANTY OF MERCHANTABILITY AND THE WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, ARE HEREBY MODIFIED TO EXIST ONLY AS CONTAINED IN THIS LIMITED WARRANTY, AND SHALL BE OF THE SAME DURATION AS THE WARRANTY PERIOD STATED ABOVE. SOME STATES DO NOT ALLOW LIMITATIONS ON THE DURATION OF AN IMPLIED WARRANTY, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU. This warranty service is available by either (a) returning the product to the dealer from whom the unit was purchased, or (b) mailing the product, along with proof of purchase, postage prepaid to the authorized service center listed below. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE INTERMATIC FL150HPS
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual INTERMATIC FL150HPS will begin.
