User manual INTERMATIC HA07

[. . . ] Thank you for purchasing Intermatic's Home Settings devices. With these products you can reliably and remotely control lighting and appliances. The outstanding features of the Home Settings program include: Feedback that will allow you to see whether your device has received the ON/OFF/DIM signal. Ease of installation Manual override RF signal reliability ­ each Home Settings product has a special repeater feature that virtually guarantees that RF signals are received. [. . . ] The INCL icon and TRANSMITTING message will begin to flash, indicating that the controller is ready to include modules to the system. (If INCL and TRANSMITTING stop flashing, the controller has "timed out". The INCLUDE button must be pressed again). Page 14 of 35 INCLUDE Modules to a Network (continued) 2. (See Fig 8b) Press and release the PROGRAM button on the module. If successful, the INCL icon will stop flashing and the word SUCCESSFUL will show for 2 seconds. If NOT SUCCESSFUL appears on the screen, it will be necessary to repeat this step until SUCCESSFUL appears. Repeat steps 1 and 2 for each module you wish to add to the network. Fig 8a ­ Press and release the INCLUDE button Fig 8b ­ Press the PROGRAM button Page 15 of 35 Associating Modules to Channels 1. (See Fig 9a) On the remote controller, simultaneously press and hold the channel ON and OFF buttons of the desired channel. (Note: Learning mode will time out after 10 seconds. If this happens, ON and OFF buttons have to be pressed again). Release the ON and OFF buttons after "LEARN" appears in the display. (See Fig 9b) Press and hold the INCLUDE button. (See Fig 9c) CONTINUTE TO HOLD THE INCLUDE BUTTON. You may now set a scene for your channel by pressing the PROGRAM button on the module until you reach your desired light-level setting. 3. 5. settings are FULL ON, FULL OFF or DIM LEVEL. Setting different light levels for different modules allows you to create "scenes" for each channel. NOTE: Only HA03 Lamp Module and HA06 In-Wall Switch/Dimmer have dimming capabilities. Release the INCLUDE button on the remote controller. After you release the INCLUDE button, the controller will store the current light-level and SUCCESSFUL will display on the controller for 2 seconds and the module LED will flash for 2 seconds. To add additional devices, repeat steps 1 ­ 4. Associating Modules to Channels (continued) Fig 9a ­ Press and hold the channel ON and OFF buttons. Release buttons when "LEARN" is shown in the display. Fig 9b ­ Press and hold the INCLUDE button. Fig 9c ­ Set the desired light level by pressing the PROGRAM button on the module. If not successful, repeat steps 1-3. 2. [. . . ] Re-associate the module (see page 16) as a `FULL ON' or as a dimmed light level. · After programming your events, press MODE until the LCD display indicates `AUTO' or `AUTORAND' mode. · My programmed events will not automatically execute. Page 33 of 35 ___Federal Communications Commission Statement___ This device complies with part 15 of the FCC rules. Operation of this device is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ]