User manual INTERMATIC HA09

[. . . ] Thank you for purchasing Intermatic's HomeSettings devices. With these products you can reliably and remotely control lighting and appliances. The outstanding features of the HomeSettings program include: Feedback that will allow you to see whether your device has received the ON/OFF/DIM signal. Ease of installation RF signal reliability ­ each HomeSettings product has a special repeater feature that virtually guarantees that RF signals are received. [. . . ] Press and release the INCLUDE button Creating a Network (continued) 3. (See Fig 3c) Press and release the programming button on the module. If successful, the LED on the controller and module will turn solid green. If not successful, the red LED will flash and it will be necessary to repeat steps 2 and 3 until the green LED on the controller turns solid green and does not flash. Repeat steps 2 and 3 for each module you wish to include into the network. Fig 3c. Press and release the programming button 4. Page 8 of 20 1. 2. 3. Associating Modules to Channels (See Fig 4a on page 10) On the remote controller, simultaneously press and hold the ON and OFF buttons of the desired channel. Both red and green LED's will flash. (Note: The LED's will time out after 10 seconds. If this happens, ON and OFF buttons have to be pressed again). (See Fig 4b on page 10) Press and hold the INCLUDE button. (See Fig 4c on page 10) While holding the INCLUDE button, press the program button on the module. Choose a light level holding the module PROGRAM 4. 5. button until you have set the desired light level. Possible settings are FULL ON, FULL OFF or DIM LEVEL for dimmable modules, (NOTE: Only HA03 Lamp Module and HA06 In-Wall Switch/Dimmer have dimming capabilities) or FULL ON, or FULL OFF for non-dimmable modules. After setting your desired light level, release the INCLUDE button on the remote controller. The green LED's on the controller and module will flash. To include additional devices to the channel, repeat steps 1 ­4. Page 9 of 20 Associating Modules to Channels (continued) Fig 4a. Press and hold the Channel ON and OFF buttons Fig 4b. Press and hold the INCLUDE button Fig 4c. Press and release the programming button Page 10 of 20 Exclude from Network (See Fig 5a and 5b) Follow the same procedure as Creating a Network except press the DELETE button instead of the INCLUDE button. Exclude from Channel (See Figures 6a, b, c) Follow the same procedure as Associating Modules to Channels except press and hold the DELETE button instead of the INCLUDE button. Fig 5a. Press and release the DELETE button Fig 5b. Press and release the programming button Fig 6a. Press and hold Channel ON and OFF until LEDs flash. Page 11 of 20 Fig 6b. Press and hold the DELETE button. Fig 6c. Press and release the Programming Button. Remote ON, OFF, DIM Operation (See Fig 7) ON ­ Press and release the ON button for the assigned channel. [. . . ] If not successful the red and green LED's will flash for 2 seconds. (Note: If the secondary controller is HomeSettings Model HA07 Master Remote Controller, follow the same procedure as the HA09 Handy Remote. Operation of this device is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ]