User manual INTERMATIC IG3240RC

[. . . ] Replace the unit. MODEL IG3240RC INSTALLATION INSTRUCTIONS TEN YEAR PRODUCT WARRANTY SURGE PROTECTION DEVICES If within ten (10) years from the date of purchase, this surge protection device fails due to defect in material or workmanship, Intermatic Incorporated will repair or replace it free of charge. The warranty does not apply to: (a) damage caused by accident, abuse, mishandling, dropping; (b) units which have been subject to unauthorized repair, opened, taken apart; (c) units not used in accordance with directions; (d) damages exceeding the cost of the product. Some states do not allow a limitation of damages, so the foregoing limitations may not apply to you. [. . . ] NOTE: ELECTRICAL GROUND IS REQUIRED FOR THIS UNIT TO FUNCTION PROPERLY AND SAFELY! INTERMATIC INCORPORATED SPRING GROVE, ILLINOIS 60081-9698 HTTP: WWW. INTERMATIC. COM STEP 1 Select a mounting location for the Surge Protection Device (SPD) which will allow convenient connection to the panel while keeping the lead wires as short as possible. Use an AC voltmeter or circuit tester across two breaker outputs to confirm that there is 240 volts between them. If the voltage is 0, select a different breaker of equal amperage. 158IG11205 STEP 2 Check all parts to be sure none are missing. You should have: QUANTITY DESCRIPTION 1 IG3240RC Panel Protector with a threaded connector and locking nut. 1 Conduit Nut STEP 10 The two black wires remaining must be connected to two separate 15 or 20 amp circuit breakers, not to each other, to insure connection across the full 240 volt AC incoming power circuit. Use the AC voltmeter or circuit tester across the black wire connection to be sure the protector is providing full protection to your panel. Not more than one wire should be connected to circuit breaker. It may be necessary to add new breakers. STEP 3 Select the mounting for the protector at the panel. If you have a panel that is not like the diagram (Fig. 3) call (815) 675-7000 for assistance between 8:00 am and 4:00 pm, weekdays, central time. STEP 11 Check to be sure all wires are securely fastened and all screws are tight. You can confirm that the protector is wired to the correct breakers if you can read 220 to 240 volts AC between the two breakers that the protector is connected to. If there is no voltage between the two breakers, check to be sure that both of the breakers and the master breaker are "ON". If there is still no voltage between the two breakers, then they are probable on the same leg, and you will have to select another breaker for one of the black wires. BE SURE TO TURN OFF THE MAIN BREAKER BEFORE YOU ATTEMPT TO MOVE ANY WIRES. Replace the front trim panel on the circuit breaker panel. (continued on back. . . ) STEP 4 If you do not have a main power shut "OFF" (master switch) do not attempt the work. [. . . ] The black wires should be connected next to each other to two 15 or 20 ampere circuit breakers. NOTE: The protector functions best if all bends in the wires are rounded, ideally to a 4" radius. DO NOT COIL EXCESS LEAD. STEP 8 Route the green wire to the ground bus bar provided in the breaker panel. [. . . ]