User manual INTERMATIC PA122

[. . . ] PA122 - WATER TEMPERATURE SENSOR KIT ATTENTION: If the Intermatic panel in which you are installing this Water Temperature Sensor Kit is not equipped with a low voltage compartment raceway, then you will need to order and install the Intermatic Class 2 Wiring Isolation Kit. The part number to order this is 156PA12976A. NEC, UL & CSA require a double barrier of insulation between high and low voltage wiring when both are present in the same compartment. [. . . ] Follow the directions below to install and mount your water temperature sensor. Drill a 3/8" hole in the pipe between the filter pump and filter and install the Water Temperature Sensor with hose clamp (not provided). Ensure the O-ring is in place. Water Temp Wires (Black/White) Cable to P4232ME Cable to P1353ME Make connection with connectors provided Fireman's Switch Wires (Brown/Brown) Wires from Water Temp Sensor (Black/White) (178PE4) Figure 1-1 2. Run the wire to the Control Center, through the low voltage raceway. Connect both wires to the Panel-Mounted Receiver. (See Figure 1-1. ) Setting Pool and Spa Temperatures If connected and linked, the Hand-Held Remote controls the independent water temperatures of both the pool and spa. View the current temperature on the right side of the Hand-Held Remote Screen under the word SET. · P = current pool water set temperature · S = current spa water set temperature POOL STAT OK 72 ºF SET P 72 S 85 2. Press and release the <P/S> button if necessary to change the system between Pool and Spa mode. Depending on which mode is selected, the word POOL (lower left) or SPA (lower right) appears on the screen 3. Press the <UP> or <DOWN> arrow buttons to raise or lower the setting to the desired temperature. You can hold the button down and the value will automatically change. Release the arrow button when the setting reaches the temperature you want. After a few seconds, the display returns to the current temperature of the pool or spa, depending on which mode you select. Copyright © 2006 Intermatic, Inc. 158PE13068. indd 1 11/2/06 12:23:29 PM LIMITED 1 YEAR WARRANTY If within one (1) year from the date of purchase, this product fails due to a defect in material or workmanship, Intermatic Incorporated will repair or replace it, at its sole option, free of charge. [. . . ] SOME STATES DO NOT ALLOW LIMITATIONS ON THE DURATION OF AN IMPLIED WARRANTY, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU. This warranty service is available by either (a) returning the product to the dealer from whom the unit was purchased, or (b) mailing the product, along with proof of purchase, postage prepaid to the authorized service center listed below. This warranty is made by: Intermatic Incorporated/After Sales Service/7777 Winn Rd. , Spring Grove, Illinois 60081-9698/815675-7000 http://www. intermatic. com Please be sure to wrap the product securely to avoid shipping damage. INTERMATIC INCORPORATED SPRING GROVE, ILLINOIS 60081-9698 http:\\www. intermatic. com 158PE13068 158PE13068. indd 2 11/2/06 12:23:29 PM [. . . ]