User manual INTERMATIC ST01C

[. . . ] The Astronomic and Specific switching times are in conflict. For example, you've set ON to DUSK and OFF at 8 pm, and due to seasonal changes, DUSK has advanced to 8:30 pm. NOTE: Your switch timer automatically skips any conflicting ON event as summer approaches to prevent unwanted operation of lights or other controlled devices. See "What to Do" if you want to identify and remove conflicting settings. [. . . ] SOME STATES DO NOT ALLOW LIMITATIONS ON THE DURATION OF AN IMPLIED WARRANTY, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU. This warranty service is available by either (a) returning the product to the dealer from whom the unit was purchased, or (b) mailing the product, along with proof of purchase, postage prepaid to the authorized service center listed below. This warranty is made by: Intermatic Incorporated/After Sales Service/7777 Winn Rd. , Spring Grove, Illinois 60081-9698/815-675-7000 http://www. intermatic. com Please be sure to wrap the product securely to avoid shipping damage. 1. Turn off power at the service panel by REMOVING FUSE or TURNING THE CIRCUIT BREAKER OFF. 2. Trim building wires to 7/16" as shown. If a Single Switch Setup: 7/16" g. Connect one of the two wires BLACK WIRE INTERMATIC INCORPORATED SPRING GROVE, ILLINOIS 60081-9698 158ST13133 from the wall to the black wire from the switch timer, using the twist connectors provided. Connect the other wire from the wall to the blue wire from RED WIRE the switch timer, using the (capped, not connected) twist connectors provided. NOTE: The RED wire is not used in single-switch installations. Cap with a twist connector. NOTE: For new construction or to replace a dimmer switch, a lighted switch, or a 3-way switch without screw terminals, a single-pole switch can be used at the remote location, as shown. NOTE: If the building's wiring colors don't allow you to tell wire "A" from "B, " just pick one of the two wires and connect as if it is wire "B. " After the installation is complete, if the controlled light or device will not turn on properly, simply reverse wires "A" and "B. " See Steps J and K for how to check. Tuck wires into the timer wall box leaving room for the timer. Verify that the day of the week is correct (Fig. If wrong, press + or ­ to loop back, then reset the calendar information. 8), and set whether you want to adjust automatically for Daylight Saving Time (DST). - If you do not use DST, press + for MANual. Press ON/OFF to set your North ZONE (Fig. This feature North tracks changes in sunrise Center Center and sunset times. Press + to select your local zone: NoRTH, CENTer, or SOUth South South (Fig. You can set DAWN or DUSK to your exact time in your area according to your newspaper or online. Use the following procedures to do so, or press ON/OFF 3 times to skip. for DAWN (Fig 11), then press + to set the correct HOUR. 12), then press + until the correct minute is shown. [. . . ] NOTE: If you go too far, press the ­ to back up, or press + until you loop back around. Press ON/OFF to display the minutes (Fig. 21), then press + until the correct minute is shown. Press ON/OFF to display the days you want the setting to be active, then press + to select either a specific day of the week, ALL days, MF (work week only), or WKD (weekend only). [. . . ]