User manual INTERMATIC T172

[. . . ] Lamp and housing become very hot during use. Ensure free air circulation around unit to dissipate heat. Avoid enclosed locations and locations where flammable debris (leaves, cut grass, etc. ) might collect. [. . . ] Avoid enclosed locations and locations where flammable debris (leaves, cut grass, etc. ) might collect. Avoid locations where humans or animals might accidentally touch fixture. WARNING: Explosion hazard Never operate light without securing the lens door. When light is operating, the gas in the lamp inner arc tube is at high pressure. Never operate light if the fixture lens or outer glass envelope of the lamp is broken or missing. WARNING: Explosion hazard Wear safety glasses and gloves when handling lamp, High Pressure Sodium outer envelope is under vacuum and could implode. Screws Mounting Plate Lens Cover Locknut Inside Fixture Figure 1 HINGE Figure 2 MOUNTING & WIRING 1. Loosen (2) screws, open, and remove fixture lens cover. Set lens cover aside to prevent damage while installing. Remove locknut from mounting plate threaded nipple inside fixture. Apply provided gasket to back of mounting plate for sealing against junction box. X3 X1 IGN-01 120 V COM LAMP 5. Remove old lamp and replace with new lamp of correct type and wattage. Screw lamp into socket in lampholder until finger-tight. Install, close, and secure lens cover with (2) screws making sure that gasket is properly seated, free of debris, and compressed to seal out moisture. Properly dispose of lamp per manufacturer's recommendations. CAUTION: Use lamp of correct type and wattage as specified on fixture. If within one (1) year from the date of purchase, this product fails due to a defect in material or workmanship, Intermatic Incorporated will repair or replace it, at its sole option, free of charge. This warranty is extended to the original purchaser only and is not transferable. This warranty does not apply to: (a) damage to units caused by accident, dropping or abuse in handling, acts of God or any negligent use; (b) units which have been subject to unauthorized repair, opened, taken apart or otherwise modified; (c) units not used in accordance with instructions; (d) damages exceeding the cost of the product; (e) sealed lamps and/or lamp bulbs; (f) the finish on any portion of the product, such as surface and/or weathering, as this is considered normal wear and tear; (g) transit damage, initial installation costs, removal costs, or reinstallation costs. INTERMATIC INCORPORATED WILL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU. [. . . ] INTERMATIC INCORPORATED WILL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU. THIS WARRANTY IS IN LIEU OF ALL OTHER EXPRESS OR IMPLIED WARRANTIES. [. . . ]