User manual INTERMATIC WL070HPSPC

[. . . ] Follow all applicable electrical codes and regulations. Read instruction sheet carefully before installing fixture. Retain instructions for future reference. WARNING: Electric shock hazard Disconnect power at circuit breaker or fuse box before installing or servicing light. WARNING: Fire hazard USE MIN 90ºC SUPPLY CONDUCTORS. CONNECT TO SUPPLY IN EXTERNAL JUNCTION BOX ONLY. [. . . ] Mounting with two bolts - Knock out two slugs in the rear housing. Mounting on outlet box - Knock out appropriate holes around outlet hole in rear housing. Fasten the rear housing to the outlet box using the screws supplied with the outlet box. Optional bottom conduit entrance - Drill out and tap recessed indentation in the bottom of rear housing. To weather proof the fixture, be sure to seal all holes in fixture housing (mounting conduit, plugs, photo controls, etc. ) with silicone sealant. Fixture lens cover Screw Screw Screws Reflector Figure 1 Grounding Screw Conduit Entry Ground Lead Figure 2 Photocontrol Knock-out 4. Using provided twist on or other approved connectors, connect the fixture wires to the supply wires as follows: (See Figure 5) a. Connect the Black fixture wire to the Black (hot) supply wire. Connect the White fixture wire to the White (neutral) supply wire. Connect the supply grounding wire to the fixture by hooking it around the green grounding screw between the brass washer and screw head. Tighten the screw securely. X3 X1 IGN-01 120 V COM LAMP Figure 3 Black Figure 4 White 5. 8. LAMP REPLACEMENT Replace reflector; secure it with (2) screws. Screw lamp into socket in lamp holder until finger-tight. Replace fixture lens cover, secure it with (2) screws. To operate, restore power to the circuit and switch light on. Figure 5 COM X2 If within one (1) year from the date of purchase, this product fails due to a defect in material or workmanship, Intermatic Incorporated will repair or replace it, at its sole option, free of charge. This warranty is extended to the original purchaser only and is not transferable. This warranty does not apply to: (a) damage to units caused by accident, dropping or abuse in handling, acts of God or any negligent use; (b) units which have been subject to unauthorized repair, opened, taken apart or otherwise modified; (c) units not used in accordance with instructions; (d) damages exceeding the cost of the product; (e) sealed lamps and/or lamp bulbs; (f) the finish on any portion of the product, such as surface and/or weathering, as this is considered normal wear and tear; (g) transit damage, initial installation costs, removal costs, or reinstallation costs. [. . . ] Remove old lamp and replace with new lamp of correct type and wattage. Screw lamp into socket in lamp holder until finger-tight. Secure it with (2) screws, making sure that gasket is properly seated, free of debris, and compressed to seal out moisture. [. . . ]