Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual INTERMATIC WL100HPS. We hope that this INTERMATIC WL100HPS user guide will be useful to you.
Lastmanuals help download the user guide INTERMATIC WL100HPS.
Detailed instructions for use are in the User's Guide.
[. . . ] A mounting suitable for outdoor use and rated for wet locations is required. Follow all applicable electrical codes and regulations.
WARNING: Electric shock hazard WARNING: Fire hazard
Disconnect power at circuit breaker or fuse box before installing or servicing light. [. . . ] If supply voltage is lower, cap wire marked 277V with appropriate twist on wire connector and strip fixture wire marked with matching voltage. (See Figure 3 or Figure 4)
240 V CAP 277 V X3 X1 240 V CAP 277 V X3 X1
208 V 120 V COM
IGN-01 X2
LAMP
208 V 120 V COM
IGN-02 X2
LAMP
8. 16.
7.
WL100MH (Metal Halide) Figure 4 Feed the matching voltage fixture wire, fixture wire marked "COM", and bare copper fixture grounding wire through the locknut and then out of the fixture. Confirm all unused voltage fixture wires are appropriately capped within fixture body. Feed the (3) fixture wires outside of the fixture through the threaded nipple of the mounting plate. Using provided twist on or other approved connectors, connect the fixture wires to the supply wires. Connect the selected voltage fixture wire to the Black (hot) supply wire. Connect the White fixture wire marked "COM" to the White (neutral) supply wire. Connect the bare copper (fixture ground) wire to the supply grounding wire. Install mounting plate on junction box with connections in the box. Install fixture over mounting plate nipple and tighten locknut to secure fixture body to mounting. (See Figure 2) Install reflector and secure with (2) screws. Screw lamp into lampholder until finger-tight. Install, close, and secure lens cover with (4) screws making sure that the gasket is properly seated. [. . . ] SOME STATES DO NOT ALLOW LIMITATIONS ON THE DURATION OF AN IMPLIED WARRANTY, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU. This warranty service is available by either (a) returning the product to the dealer from whom the unit was purchased, or (b) mailing the product, along with proof of purchase, postage prepaid to the authorized service center listed below. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE INTERMATIC WL100HPS
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual INTERMATIC WL100HPS will begin.
