User manual INTERMATIC WL250HPS

[. . . ] A mounting suitable for outdoor use and rated for wet locations is required. Follow all applicable electrical codes and regulations. WARNING: Electric shock hazard WARNING: Fire hazard Disconnect power at circuit breaker or fuse box before installing or servicing light. [. . . ] If supply voltage is lower, cap wire marked 277V with appropriate twist on wire connector and strip fixture wire marked with matching voltage. (See Figure 3 or Figure 4) 277 V 240 V 208 V 120 V COM CAP X3 X1 277 V CAP 240 V 208 V 120 V COM IGN-01 LAMP LAMP 5. Feed the matching voltage fixture wire, fixture wire marked "COM", and bare copper fixture grounding wire through the locknut and then out of the fixture. Confirm all unused voltage fixture wires are appropriately capped within fixture body. Using provided twist on or other approved connectors, connect the fixture wires to the supply wires. Connect the selected voltage fixture wire to the Black (hot) supply wire. Connect the White fixture wire marked "COM" to the White (neutral) supply wire. Connect the bare copper (fixture ground) wire to the supply grounding wire. Install reflector and secure with (4) screws. Screw lamp into lampholder until finger-tight. Install, close, and secure lens cover with (2) screws making sure that the gasket is properly seated. To weatherproof fixture, seal all holes in housing (mounting conduit, plugs, photocontrols, etc. ) with silicone sealant. [. . . ] SOME STATES DO NOT ALLOW LIMITATIONS ON THE DURATION OF AN IMPLIED WARRANTY, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU. This warranty service is available by either (a) returning the product to the dealer from whom the unit was purchased, or (b) mailing the product, along with proof of purchase, postage prepaid to the authorized service center listed below. [. . . ]