User manual INTERMATIC WP1000HC

[. . . ] listed for outdoor or indoor applications such as greenhouses, manu-facturing plants, milking parlors, poultry houses and other such applications. This weatherproof receptacle cover should be installed on a smooth flat non-porous surface such as flat enameled siding, flat aluminum siding or equivalent with no joints, cracks, gaps, ribs, protrusions or other irregularities under them. This weatherproof receptacle cover is designed to provide protection for permanently or semi-permanently installed appliances such as rotisseries, low voltage outdoor lighting, holiday lighting or other such permanent or semi-permanent power requirements. This receptacle cover is designed to protect the receptacle from moisture "while in use" for safety and to prevent nuisance tripping of the circuit breaker. [. . . ] Neoprene gasket with slits for mounting screws. Baggie assembly with 4 long mounting screws and 2 short mounting screws. INSTALLATION CAUTION: DISCONNECT POWER TO THE RECEPTACLE AT THE CIRCUIT BREAKER PANEL BEFORE INSTALLING THIS RECEPTACLE COVER. ® CAUTION: DISCONNECT POWER TO THE RECEPTACLE AT THE CIRCUIT BREAKER PANEL BEFORE INSTALLING THIS RECEPTACLE COVER. To install your receptacle cover, follow the steps listed. IF USING A POWER SCREWDRIVER, BE CAREFUL NOT TO OVER TIGHTEN THE SCREWS BECAUSE YOU WILL STRIP THE THREADS IN THE JUNCTION BOX AND/OR THE ELECTRICAL DEVICE. If installation is being done on an existing receptacle, remove the existing receptacle cover and discard. The mounting screws which hold the receptacle or GFI to the junction box can be removed. Do not remove receptacle wiring connections. Select the proper insert and press insert into base/cover assembly. Press insert firmly into this assembly and it will remain there during the remaining assembly steps. Locate gasket as required for the installation. Be sure gasket is held to the back of the base/cover and insert assembly using the four projections molded on the insert to locate the gasket. Mount the cover/base and insert assembly, hinge on top, and the existing receptacle to the junction box using two of the long screws provided (DO NOT OVER TIGHTEN). If mounting to an outdoor junction box or field service (FS) box, use the remaining long screws, two or four screws as required, to further secure the cover/base and insert assembly to the box. Note that holes are located in the insert for mounting to an FS box or any standard single gang junction box. For specially designed junction boxes, holes should be carefully drilled to line up with the holes in the junction box to accommodate mounting. Be sure all screws are secure but not over tightened. Then install the remaining one or two short screws into the receptacle as required. [. . . ] This warranty gives you specific legal rights and you may also have other rights which may vary from state to state. This warranty service is available by a) returning the product to the dealer from whom it was purchased or b) mailing postage prepaid to the address listed below. Please be sure to wrap the product securely when mailing to avoid shipping damage. [. . . ]